1 / 9

f/5 Mirror Support Servo Operation

f/5 Mirror Support Servo Operation. MMT Observatory D. Clark 4/6/2007. Necessary Conditions for Proper Mirror Support Operation. Hardpoints properly locate and define the mirror location w.r.t. the mirror cell Hardpoint force measurements are linear w.r.t. the actual mirror position

iolana
Download Presentation

f/5 Mirror Support Servo Operation

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. f/5 Mirror Support Servo Operation MMT Observatory D. Clark 4/6/2007

  2. Necessary Conditions for Proper Mirror Support Operation • Hardpoints properly locate and define the mirror location w.r.t. the mirror cell • Hardpoint force measurements are linear w.r.t. the actual mirror position • The axial support plane and the plane of the mirror back surface are parallel; in addition, all axial support actuators are at the same height w.r.t. the back surface in their nominal operating position • The lateral actuator support locations and the CG plane are coplanar • The lateral hardpoints ideally are mounted in the CG plane

  3. F5 Axial Servo Block Diagram Σ SERVO CIRCUIT FORCE BIAS AIR VALVE HARD POINT LOAD CELL x200 1 OF 3 IDENTICAL SERVO LOOPS

  4. F5 Lateral Servo Block Diagram Σ SERVO CIRCUIT FORCE BIAS AIR VALVE Tangent Rod LOAD CELL x200 Zero Adj LOAD CELL x200 Zero Adj Tangent Rod

  5. Circuit Operation • An adjustable setpoint equal to the “assembled” hardpoint force is used as the force reference voltage. • The servo loop PI gain forces the mirror support air transducers to cancel the gravity load of the mirror. • A “soft-start” is provided to keep the loop integrator from windup at turn-on. • If insufficient air pressure is present, the air valve outputs are switched off.

  6. Overall Block Diagram

  7. Current Design Features • Input DC is locally regulated on-board • Precision voltage references used for load cell excitation and generation of bias-offset and force-reference circuits • Both bias-offset and force-reference voltages are fully adjustable for all servo circuits • Anti-windup and graceful shutdown for force loop integrators • Extensive use of SMT; parts we “expect” to replace are socketed • uP-based DAQ for live support system telemetry

  8. Design Improvements • Reduce the number of adjustments; only force-reference is really necessary • Add a single connector for convenient attachment of test equipment, instead of hunting all over the board for test points • Improve the board layout for better signal integrity in the DAQ system • Upgrade to an Ethernet-capable uP for faster, simpler DAQ communications

  9. Conclusion • The f/5 mirror support servo is in some ways superior to its counterpart in the f/9 mirror system • The DAQ available in the f/5 system is a valuable add-on at little cost overall • Improvements can and should be pursued for follow-on wide-field secondaries, but the basic design is sound, and proven to work

More Related