1 / 10

Installation

Installation . ARIA IP - 60. ARIA IP - 60 BKSU Content. ARIA IP - 60 BKSU Content. KSU Dimensions. Opening front Cover. Open the Cord cover and turn the screws counter-clockwise to loosen as shown in Figure Lift the front cover in the direction of the arrow as shown .

silver
Download Presentation

Installation

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Installation ARIA IP - 60

  2. ARIA IP - 60 BKSU Content

  3. ARIA IP - 60 BKSU Content

  4. KSU Dimensions

  5. Opening front Cover Open the Cord cover and turn the screws counter-clockwise to loosen as shown in Figure Lift the front cover in the direction of the arrow as shown

  6. KSU Ground Connection • It is very important that the frame of the ipLDK-60 System is grounded: • Turn the grounding screw counter clockwise to loosen, as shown in Figure. • Insert the grounding wire and tighten the screw. • Then connect the grounding wire to an appropriate ground source (refer to Caution). CAUTION— The equipment should be connected to a socket-outlet with a protective ground connection. For ground wire, green-and-yellow insulation is required and the cross-sectional area of the conductor must be more than UL 1015 AWG#18 (1.0mm)). It is recommended that the ground wire is shorter than 1m (3.28ft). Proper grounding is very important to protect the ipLDK-60 from external noise or to reduce the risk of electrocution in the event of lightning strike. Be sure to comply with applicable local regulations.

  7. Battery Back-up The external batteries must provide 24V DC; this is generally accomplished by connecting two 12V batteries in a series arrangement as shown. NOTE— The cable used to connect the battery is supplied with the KSU. CAUTION— It is recommended to use an external backup battery fuse (5A @250V) between the battery and the System. Recommended battery capacity is 24V/20AH MF; Carefully check the battery polarity with cable colors Red(+) and Blue(-) when connecting the battery to the System. Make sure that you do not short out the external batteries and cables. There is a danger of explosion if external batteries are incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer.

  8. Link cable to link EKSU with BKSU

  9. Additional connections on the BKSU • The MBU provides connections • one external music source PJ1 (RED, External MOH), • one external page port PJ2 (BLUE, External Page) • two relay contact, • an alarm detection input monitor through the MJ2

  10. Questions?

More Related