1 / 13

354 Chapt . 6 X-ray Tube

354 Chapt . 6 X-ray Tube. TWO Primary components – cathode and anode Tube must be supported: Ceiling/floor mounted/C-arm, etc. SID’s Detents (center and SID’s) Over ride timer for AEC. Protective tube housing.

lulu
Download Presentation

354 Chapt . 6 X-ray Tube

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. 354 Chapt. 6 X-ray Tube • TWO Primary components – cathode and anode • Tube must be supported: Ceiling/floor mounted/C-arm, etc. • SID’s • Detents (center and SID’s) • Over ride timer for AEC

  2. Protective tube housing • X-rays are produced “isotropically” (in all directions) – tube housing allows only those directed at the “window” to escape • Leakage radiation = less than 100 mR/hr at 1 m in any direction other than the window

  3. Filament (thoriated tungsten) • 3410 F degree melting point • Tungsten wire – usually 1-2 cm long and 2mm in diameter • Dual filament (equals dual target size) • Thermionic emission • Electron cloud (space charge affect) • NEGATIVELY charged focusing cup • NEGATIVE charged side of x-ray tube

  4. Anode • Most are rotating discs to give MORE surface area for heat dissipation • 3400-10,000 rpm rotation • Angled to give LARGER actual BUT SMALLER effective F.S. • Composite – Tungsten/rhenium • Support arm assembly assists to rid anode of heat and is made of molybdnium/rhenium, tungsten and copper

  5. Brems/Breaking Radiation

  6. Characteristic Radiation

  7. Other anode attributes • Line-focus principle – actual/effective focal spot • Heel effect • Angles (smaller anode angle = LARGER heel effect • More penetrating beam on CATHODE side due to heel effect

  8. Line-focus principle/heel effect

  9. “HEAT” enemy #1! • Tube warm up is required if ONE hour or more has lapsed since the last exposure – CHECK PRIOR TO PLACING PATIENT IN THE ROOM/ON THE TABLE! • PRIMARY reason for tube failure!

  10. Tube rating charts • Variable kVp/fixed mAs – not too practical as kVp is driven by atomic mass density or the patient or contrast agent • Variable mAs/fixed OPTIMUM kVp = most practical as atomic mass number is the “driving force” of kVp and mAs = the amount of radiation produced to make the OD

  11. Tube rating chart

  12. Cooling Chart

  13. Tube Cooling Processes

More Related