1 / 12

PMSM Design

PMSM Design. Liping Zheng 06/06/2003. PMSM Configuration. Litz-wire: 1.78 mm x 2.27 mm 50 strands @ AWG 30 Gap : 0.5 mm Stator Di: 25.5 mm Do: 38 mm Length: 25.4 mm Shaft diameter: 16 mm. No major shaft stress problem if we select high stress shaft material.

Download Presentation

PMSM Design

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. PMSM Design Liping Zheng 06/06/2003

  2. PMSM Configuration Litz-wire: 1.78 mm x 2.27 mm 50 strands @ AWG 30 Gap : 0.5 mm Stator Di: 25.5 mm Do: 38 mm Length: 25.4 mm Shaft diameter: 16 mm No major shaft stress problem if we select high stress shaft material. We’ve sent out the purchase requisition form to the university.

  3. PMSM Loss Motor Efficiency: Control Efficiency: Total Efficiency:

  4. Other Possible Loss (I) • Copper loss associated with eddy current. • Skin depth : • Litz-wire : 50 @ AWG 30 (D=0.01 in or 0.25 mm) •  Eddy current can be ignored. • Copper loss associated with the airgap flux leakage. • Twisted Litz-wire can greatly reduce the loss. Twisting pitch is the same as the motor active length.

  5. Other Possible Loss (II) • Loss in the shaft. • Slotless stator can reduce this loss greatly. • Loss in the permanent magnet. • Slotless stator can reduce this loss greatly. • Loss due to nonideal control • Loss associated with non ideal control. • Loss associated with current harmonics. • Loss of the low pass filter.

  6. Verify Stator Core Loss Using FEM Simulation • Two methods to get the stator core loss: • Based on the frequency and flux density vs. Loss curve. • Based on finite element method (FEM) simulation.

  7. 45W/lb Stator Material (Arnon 5) - Loss Core loss= 10.4 W

  8. Core Loss Using FEM • At a given frequency, the iron loss for electrical steel can be calculated from: Where Kh is the hysteresis coefficient. Kc is the classical eddy coefficient. Ke is the excess eddy current coefficient. F is the frequency. Above coefficients can be calculated by the curve fitting of the manufacturer’s loss data sheet.

  9. Unit Setup Executive Parameters Curve Fitting Results:

  10. Stator Core Loss of the PMSM Core loss is 9.5W

  11. Stator Core Loss of Current or PM Only Winding mmf contributes only smaller portion of the core loss

  12. Further Work • Estimate the loss in the shaft. • Estimate the loss in the permanent magnet. • Simulation the loss of the low pass inductors. • Optimize the shaft structure.

More Related