1 / 51

Continuous intravenous infusion (one-compartment model)

Continuous intravenous infusion (one-compartment model). Dr Mohammad Issa. The drug is administered at a selected or calculated constant rate (K 0 ) (i.e. dX/dt), the units of this input rate will be those of mass per unit time (e.g.mg/hr).

jgreenberg
Download Presentation

Continuous intravenous infusion (one-compartment model)

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Continuous intravenous infusion(one-compartment model) Dr Mohammad Issa

  2. The drug is administered at a selected or calculated constant rate (K0) (i.e. dX/dt), the units of this input rate will be those of mass per unit time (e.g.mg/hr). The constant rate can be calculated from the concentration of drug solution and the flow rate of this solution, For example, the concentration of drug solution is 1% (w/v) and this solution is being infused at the constant rate of 10mL/hr (solution flow rate). So 10mL of solution will contain 0.1 g (100 mg) drug. The infusion rate (K0) equals to the solution flow rate multiplied by the concentration In this example, the infusion rate will be 10mL/hr multiplied by 100 mg/10 mL, or 100mg/hr. The elimination of drug from the body follows a first Theory of intravenous infusion

  3. IV infusion During infusion Post infusion

  4. IV infusion: during infusion where K0 is the infusion rate, K is the elimination rate constant, and Vd is the volume of distribution

  5. Steady state ≈ steady state concentration (Css)

  6. Steady state • At steady state the input rate (infusion rate) is equal to the elimination rate. • This characteristic of steady state is valid for all drugs regardless to the pharmacokinetic behavior or the route of administration.

  7. Fraction achieved of steady state concentration (Fss) since , previous equation can be represented as:

  8. Fraction achieved of steady state concentration (Fss) or

  9. Time needed to achieve steady state time needed to get to a certain fraction of steady state depends on the half life of the drug (not the infusion rate)

  10. Example • What is the minimum number of half lives needed to achieve at least 95% of steady state? • At least 5 half lives (not 4) are needed to get to 95% of steady state

  11. Example • A drug with an elimination half life of 10 hrs. Assuming that it follows a one compartment pharmacokinetics, fill the following table:

  12. Example

  13. Example

  14. IV infusion + Loading IV bolus • During constant rate IV administration, the drug accumulates until steady state is achieved after five to seven half-lives • This can constitute a problem when immediate drug effect is required and immediate achievement of therapeutic drug concentrations is necessary such as in emergency situations • In this ease, administration of a loading dose will be necessary. The loading dose is an IV holus dose administered at the time of starting the IV infusion to achieve faster approach to steady state. So administration of an IV loading dose and starting the constant rate IV infusion simultaneously can rapidly produce therapeutic drug concentration. The loading dose is chosen to produce Plasma concentration similar or close to the desired plasma concentration that will be achieved by the IV infusion at steady state

  15. IV infusion + Loading IV bolus

  16. IV infusion + Loading IV bolus • To achieve a target steady state conc (Css) the following equations can be used: • For the infusion rate: • For the loading dose:

  17. IV infusion + Loading IV bolus • The conc. resulting from both the bolus and the infusion can be described as: Ctotal =Cinfusion + Cbolus

  18. IV infusion + Loading IV bolus: Example • Derive the equation that describe plasma concentration of a drug with one compartment PK resulting from the administration of an IV infusion (K0= Css∙Cl ) and a loading bolus (LD= Css∙Vd) that was given at the start of the infusion

  19. IV infusion + Loading IV bolus: Example Ctotal =Cinfusion + Cbolus • Cinfusion: • Cbolus:

  20. IV infusion + Loading IV bolus: Example Ctotal =Cinfusion + Cbolus

  21. Case A Infusion alone (K0= Css∙Cl) Case B Infusion (K0= Css∙Cl) loading bolus (LD= Css∙Vd) Concentration Concentration Half-lives Half-lives Case C Infusion (K0= Css∙Cl) loading bolus (LD > Css∙Vd) Case D Infusion (K0= Css∙Cl) loading bolus (LD< Css∙Vd) Concentration Concentration Half-lives Half-lives Scenarios with different LD

  22. Changing Infusion Rates Increasing the infusion rate results in a new steady state conc. 5-7 half-lives are needed to get to the new steady state conc Concentration Half-lives 5-7 half-lives are needed to get to steady state Decreasing the infusion rate results in a new steady state conc. 5-7 half-lives are needed to get to the new steady state conc

  23. Changing Infusion Rates • The rate of infusion of a drug is sometimes changed during therapy because of excessive toxicity or an inadequate therapeutic response. If the object of the change is to produce a new plateau, then the time to go from one plateau to another—whether higher or lower—depends solely on the half-life of the drug.

  24. Post infusion phase During infusion Post infusion C* (Concentration at the end of the infusion)

  25. Post infusion phase data • Half-life and elimination rate constant calculation • Volume of distribution estimation

  26. Elimination rate constant calculation using post infusion data • K can be estimated using post infusion data by: • Plotting log(Conc) vs. time • From the slope estimate K:

  27. Volume of distribution calculation using post infusion data • If you reached steady state conc (C* = CSS): • where k is estimated as described in the previous slide

  28. Volume of distribution calculation using post infusion data • If you did not reached steady state (C* = CSS(1-e-kT)):

  29. Example 1 Following a two-hour infusion of 100 mg/hr plasma was collected and analysed for drug concentration. Calculate kel and V.

  30. Time is the time after stopping the infusion

  31. Example 1 • From the slope, K is estimated to be: • From the intercept, C* is estimated to be:

  32. Example 1 • Since we did not get to steady state:

  33. Example 2 • Estimate the volume of distribution (22 L), elimination rate constant (0.28 hr-1), half-life (2.5 hr), and clearance (6.2 L/hr) from the data in the following table obtained on infusing a drug at the rate of 50 mg/hr for 16 hours.

  34. Example 2

  35. Example 2 • Calculating clearance: It appears from the data that the infusion has reached steady state: (CP(t=15) = CP(t=16) = CSS)

  36. Example 2 • Calculating elimination rate constant and half life: From the post infusion data, K and t1/2 can be estimated. The concentration in the post infusion phase is described according to: where t1 is the time after stopping the infusion. Plotting log(Cp) vs. t1 results in the following:

  37. Example 2

  38. Example 2 K=-slope*2.303=0.28 hr-1 Half life = 0.693/K=0.693/0.28= 2.475 hr • Calculating volume of distribution:

  39. Example 3 • A drug that displays one compartment characteristics was administered as an IV bolus of 250 mg followed immediately by a constant infusion of 10 mg/hr for the duration of a study. Estimate the values of the volume of distribution (25 L), elimination rate constant (0.1hr-1), half-life (7), and clearance (2.5 L/hr) from the data in the following table

  40. Example 3

  41. Example 3 • The equation that describes drug concentration is: a- Calculating volume of distribution: At time zero,

  42. Example 3 b- Calculating elimination rate constant and half life: Since the last two concentrations (at time 45 and 50 hrs) are equal, it is assumed that a steady state situation has been achieved. Half life = 0.693/K=0.693/0.1= 6.93 hr

  43. Example 3 c- Calculating clearance:

  44. Example 4 • For prolonged surgical procedures, succinylcholine is given by IV infusion for sustained muscle relaxation. A typical initial dose is 20 mg followed by continuous infusion of 4 mg/min. the infusion must be individualized because of variation in the kinetics of metabolism of suucinylcholine. Estimate the elimination half-lives of succinylcholine in patients requiring 0.4 mg/min and 4 mg/min, respectively, to maintain 20 mg in the body. (35 and 3.5 min)

  45. Example 4 For the patient requiring 0.4 mg/min: For the patient requiring 4 mg/min:

  46. Example 5 A drug is administered as a short term infusion. The average pharmacokinetic parameters for this drug are: K = 0.40 hr-1 Vd = 28 L This drug follows a one-compartment body model.

  47. Example 5 1) A 300 mg dose of this drug is given as a short-term infusion over 30 minutes. What is the infusion rate? What will be the plasma concentration at the end of the infusion? 2) How long will it take for the plasma concentration to fall to 5.0 mg/L? 3) If another infusion is started 5.5 hours after the first infusion was stopped, what will the plasma concentration be just before the second infusion?

  48. Example 5 1) The infusion rate (K0) = Dose/duration = 300 mg/0.5 hr = 600 mg/hr. Plasma concentration at the end of the infusion: Infusion phase:

  49. Example 5 2) Post infusion phase: The concentration will fall to 5.0 mg/L 1.66 hr after the infusion was stopped.

  50. Example 5 3) Post infusion phase (conc 5.5 hrs after stopping the infusion):

More Related