1 / 15

The Ultimate How-To Guide to Build your Coil

So, if you have decided to build your own coil but don’t know how to build it and where to start, it’s OK because you have reached the right place.

vapourdepot
Download Presentation

The Ultimate How-To Guide to Build your Coil

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. The Ultimate How-To Guide to Build your Coil So, if you have decided to build your own vape coil but don’t know how to build it and where to start, Here is step by step guide. VapourDepot.com

  2. What you’ll need? 1) Rebuildable Dripping Atomizers (RDA) VapourDepot.com

  3. 2) Ohm Reader VapourDepot.com

  4. 3) Scissors VapourDepot.com

  5. 4) Resistance wire VapourDepot.com

  6. 5) Small propane torch VapourDepot.com

  7. 6) Thin wire cutters VapourDepot.com

  8. 7) Thin wire cutters VapourDepot.com

  9. 8) Organic cotton VapourDepot.com

  10. 9) Pliers or Tweezers VapourDepot.com

  11. Before you actually start with the coil building process, you need to know the different types of coils you can make at home. These include: Single Coils  Twisted Coils  Clapton Coils  Dual Coils 

  12. Let's start Oxidizing the wire Cut a 4-5 inch wire, hold its one end with a pair of tweezers or pliers.  Now, slowly heat the wire by using torch until it starts getting orange.  Let the wire cool and repeat the same process by holding the other end.  Oxidizing the wire will not only make it less “springy” but it would also become easier to 

  13. Wrapping the coil Place the wire at the screwdriver’s base. Leave one end longer than the other while wrapping the coil.  With the help of your finger, hold the wire against the screwdriver.  You would wrap the wire about 6-8 times, depending on the size of the RDA.  Tight the coils to remove slack and bring them

  14. Installing the coil Next, take the build deck of RDA and loose the post screws.  Don’t remove the screws completely as they are easy to lose but are hard to put back.  Take the coil (that is still on the screwdriver) and position both the leads in the positive post hole and negative post hole, respectively. 

  15. Now, you are done with the coil building process; check the structure and ensure it is built accurately. Happy Vaping........ Looking for a reputed vape store? Visit Vapourdepot.com

More Related