html5-img
1 / 12

POWER ELECTRONICS

بسم الله الرحمن الرحيم. The Islamic University of Gaza Faculty of Engineering Electrical Engineering Department. POWER ELECTRONICS. EELE 5450 — Summer 2012. Instructor: Eng . Jalal Al Roumy. Lecture 14. Chapter Five. Full-wave controller With Inductive Load.

nuri
Download Presentation

POWER ELECTRONICS

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. بسم الله الرحمن الرحيم The Islamic University of Gaza Faculty of Engineering Electrical Engineering Department POWER ELECTRONICS EELE 5450— Summer 2012 Instructor: Eng. Jalal Al Roumy Lecture 14

  2. Chapter Five Full-wave controller With Inductive Load In actual practice most loads have some amount of inductance. Motors, solenoids, transformers, and even some resistive heaters have inductive components as apart of their impedance. The effect of this reactance is that the rms-to-average-current ratio is lowered. Higher average current can be passed through the SCR. With an inductive load , current flow is maintained through the SCR even after the input voltage has reversed polarity and goes negative. The duration of this interval is determined bu the load power factor.

  3. Chapter Five Full-wave controller With Inductive Load

  4. Chapter Five Full-wave controller With Inductive Load

  5. Chapter Five Ө > φ

  6. Chapter Five Ө < φ

  7. Chapter Five Triggering by pulse train synchronization

  8. Chapter Five Motor application

  9. Chapter Five Zero Voltage Switching • The control of rms ac voltage to the load could also be • Achieved by changing the on and off periods of the ac • Input wave to the load. • There are basically two methods of control: • On-off control • Proportional control

  10. Zero Voltage Switching

  11. Synchronous tap changing If a small variation of ac output voltage is required , then the taps of a transformer would be changed by switching thyristors in the proper manner. End of Lecture

More Related