1 / 17

CHE 185 – PROCESS CONTROL AND DYNAMICS

CHE 185 – PROCESS CONTROL AND DYNAMICS. WORKSHOP 3. P-Only Control of Jacketed Reactor Temperature. Objective To design and test a P-Only controller for tracking changes in set point and rejecting disturbances. Also, to explore how controller gain impacts P-Only performance. P&ID FOR WORKSHOP.

nassor
Download Presentation

CHE 185 – PROCESS CONTROL AND DYNAMICS

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. CHE 185 – PROCESS CONTROL AND DYNAMICS WORKSHOP 3

  2. P-Only Control of Jacketed Reactor Temperature • Objective • To design and test a P-Only controller for tracking changes in set point and rejecting disturbances. Also, to explore how controller gain impacts P-Only performance.

  3. P&ID FOR WORKSHOP

  4. P&ID FOR WORKSHOP

  5. P-Only temperature control • reactor exit temperature (the measured process variable) of 91°C • PVsetpoint = • IN MANUAL MODE, movE the controller output signal until the measured variable reads 91°C • CObias =

  6. P-Only temperature control • Compute and record the FOPDT process model parameters: • Process gain, Kp= • Time constant, τp = • Dead time, θp =

  7. P-Only temperature control • the ITAE (Integral Time Weighted Absolute Error) design correlation for Set Point Tracking

  8. P-Only temperature control • changing your controller gain to search for a performance that balances offset against oscillatory behavior. Call this your "best“ KC: • “Best” KC =

  9. TYPICAL RESULTS • The set point should be at the design level of the measured process variable: • pvsetpoint = 91 oC • A P-Only controller design requires the controller bias. : • ubias = 45% • FOPDT process model parameters: • Process gain, KP = - 0.33 oC/% • Time const, P = 2.1 min • Dead time, P= 0.5 min

  10. TYPICAL RESULTS

  11. TYPICAL RESULTS

  12. TYPICAL RESULTS

  13. TYPICAL RESULTS • ITAE for Set Point Tracking tuning relation: • KC = - 3.52 %/oC

  14. TYPICAL RESULTS • USE CALCULATED PARAMETERS TO ACTIVATE AUTOMATIC CONTROL. enter Set Point, Bias and Controller Gain:

  15. TYPICAL RESULTS

  16. TYPICAL RESULTS step the set point from 91 to 95 to 99 to 103 oC

  17. TYPICAL RESULTS

More Related