1 / 9

Mechanics of Materials – MAE 243 (Section 002) Spring 2008

Mechanics of Materials – MAE 243 (Section 002) Spring 2008. Dr. Konstantinos A. Sierros. Problem 5.4-4

myra-joseph
Download Presentation

Mechanics of Materials – MAE 243 (Section 002) Spring 2008

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Mechanics of Materials – MAE 243 (Section 002) Spring 2008 Dr. Konstantinos A. Sierros

  2. Problem 5.4-4 A cantilever beam AB is loaded by a couple M0 at its free end (see figure). The length of the beam is L = 1.5 m and the longitudinal normal strain at the top surface is 0.001. The distance from the top surface of the beam to the neutral surface is 75 = mm. Calculate the radius of curvature , the curvature , and the vertical deflection at the end of the beam.

  3. Problem 5.5-3 A thin, high-strength steel rule (E = 30 x (10^6) psi) having thickness t = 0.15 in. and length L = 40 in. is bent by couples M0 into a circular arc subtending a central angle θ = 45° (see figure). (a) What is the maximum bending stress in the rule? (b) Does the stress increase or decrease if the central angle is increased?

  4. 5.6: Design of beams for bending stresses • When designing beams many factors must be considered. Some of them are: • Type of structure (airplane, automobile, bridge, buildings…) • Materials to be used • Loads to be supported • Environmental conditions • Cost

  5. 5.6: Design of beams for bending stresses • When designing beams to resist bending stresses, which are very important, we should begin by calculating the required section modulus • The allowable stress is based on the properties of the material and the desired factor of safety

  6. 5.6:Beams of standardized shapes and sizes • Structural steel sections • The standardized steel sections are manufactured by a process called rolling • Aluminum structural sections • Aluminum structural sections are manufactured by a process called extrusion • Wood beams • They are surfaced in order to be smoother

  7. 5.6:Relative efficiency of various beam shapes • It can be shown that a beam of a very narrow rectangular section will fail due to lateral buckling • A beam of a square cross-section is more efficient in resisting bending than is a circular beam of the same area. Why? • Because a circle has a relatively larger amount of material located near the neutral axis

  8. 5.6: Nonprismatic beams • Nonprismatic beams have varying section modulus S • We use nonprismatic beams for weight reduction and aesthetic reasons

  9. Friday: QUIZ on Chapter 4 Duration 20 minutes 1 question to answer

More Related