1 / 10

Detection Circuit

Detection Circuit. ENGR 1182.03 Lecture. Learning Objectives of Lab. Students will learn about – Electronic circuit components Building the binary voltmeter circuit from a schematic drawing Troubleshooting electronic circuits Binary numbers and binary-decimal conversion. excitation.

charper
Download Presentation

Detection Circuit

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Detection Circuit ENGR 1182.03 Lecture

  2. Learning Objectives of Lab • Students will learn about – • Electronic circuit components • Building the binary voltmeter circuit from a schematic drawing • Troubleshooting electronic circuits • Binary numbers and binary-decimal conversion

  3. excitation emission Fluorescein Detection detection well Acrylic chip blue LED photodetector

  4. Schematic

  5. TASK 1 - Check the Breadboard Setup Connect to 5 v. Power Supply Measure the Power Supply Voltage, V = ______ Volts +5V Short wire Ground

  6. TASK 2 - Binary Voltmeter Circuit • Insert Binary Voltmeter Board • Insert eight LEDs • Connect Gndon Binary Voltmeter Board to Ground on Breadboard. • Connect the DMM Positive wire to V Input • Connect a wire from Vinput first to +5 Volts and then to Ground. Verify all LEDs turn on and off respectively. LED short wire on this side, negative terminal connected to ground

  7. TASK 3 – Binary Voltmeter Calibration Circuit • Place the TrimPot as shown and: • Connect Pin 1 to Ground • Connect Pin 3 to +5 V • Connect Pin 2 to V Input on the Binary Voltmeter +5V Ground

  8. Use the Lab Procedure Document for detailed instructions!

  9. Calibrate the Binary Voltmeter CircuitWorksheet A

  10. DAD Verification Fluorescein Detection Circuit Diode (2 wires) Photo-Transistor (3 wires) Check DAD- Polarity is critical. Have instructors check. DAD

More Related