1 / 2

Work instructions for checking drilling on nut plate100 & 400 by receiving Gauge

Work instructions for checking drilling on nut plate100 & 400 by receiving Gauge. 5. 5. 3. 5. Work instructions:- Clean the plate before use. fix the orientation pins marked 2 & 2a at angle 8.47 ° milling sides as shown in photo. Keep the gauge on surface plate

abel-spence
Download Presentation

Work instructions for checking drilling on nut plate100 & 400 by receiving Gauge

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Work instructions for checking drilling on nut plate100 & 400 by receiving Gauge 5 5 3 5 Work instructions:- Clean the plate before use. fix the orientation pins marked 2 & 2a at angle 8.47° milling sides as shown in photo. Keep the gauge on surface plate For further process please see next slide. 3 5 2 5 5 3 5 3 2a 5 Receiving Gauge 2&2a- Orientation pin 3 – location pin 5- notch pins total 8Nos.

  2. Work instructions for checking drilling on nut 100 / 400 plate by receiving Gauge 2 2a Work instructions:- Put the job in plate in such way that the job location should within pins (marked 3) at OD 116.790 on the job & orientation should at orientation pins marked 2 & 2a at angle 8.47° milling sides as shown in photo. Ensure that the job is located & oriented properly. Ensure that the checking pins (marked 5) are qualifying through the notches of the job . At the same time ensure that there should not be any air gap between orientation pins 2/2a and the respective milling surface. 5 3

More Related