1 / 24

Plastic Closure Designs 1) Malloy (referenced) 2) GE Design Guide (PDF) Table X or Figure Y

Plastic Closure Designs 1) Malloy (referenced) 2) GE Design Guide (PDF) Table X or Figure Y. GE. TEC 316 Dr. Lou Reifschneider. GE. Clamshell Assembly Options. Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.45.

verity
Download Presentation

Plastic Closure Designs 1) Malloy (referenced) 2) GE Design Guide (PDF) Table X or Figure Y

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Plastic Closure Designs1) Malloy (referenced)2) GE Design Guide (PDF)Table X or Figure Y GE TEC 316 Dr. Lou Reifschneider

  2. GE

  3. Clamshell Assembly Options Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.45.

  4. Self tapping screw must have clearance through boss and then a blind pilot boss. Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.46.

  5. Cantilever snap molded with two-plate mold Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.32.

  6. CantileverSnap Closure Options Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.14.

  7. Deflection sequence for a U-shaped cantilever snap Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.20.

  8. Cantilever snaps to hold components: two designs Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.21. Locating feature for cover

  9. GE

  10. GE

  11. GE

  12. Schematic of Ultrasonic Welder Plastic Part Design for Injection Molding by Robert A. Malloy, Fig. 6.95.

  13. GE

  14. GE

  15. GE

  16. GE

  17. GE

  18. GE

  19. GE

  20. GE

  21. GE KISS-OFF Vent holes made WITHOUT side action.

  22. GE

  23. GE

  24. GE

More Related