1 / 9

BNL - FNAL - LBNL - SLAC

BNL - FNAL - LBNL - SLAC. Long Quadrupole Quench Protection G. Ambrosio, G. Chlachidze, C. Donnelly S. Rahimzadeh-Kalaleh. Measurement & Analysis Group Meeting July. 20, 2007. OUTLINE: LQ Quench protection Spikes recorded during TQS02 test. Magnet parameters.

spercy
Download Presentation

BNL - FNAL - LBNL - SLAC

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. BNL - FNAL - LBNL - SLAC Long Quadrupole Quench Protection G. Ambrosio, G. Chlachidze, C. Donnelly S. Rahimzadeh-Kalaleh Measurement & Analysis Group Meeting July. 20, 2007 OUTLINE: • LQ Quench protection • Spikes recorded during TQS02 test LQ Quench Protection – G. Ambrosio

  2. Magnet parameters LQ Quench Protection – G. Ambrosio

  3. TQC01 protection heater studies by using spot heaters to initiate the quench. TQs Heater Delay & Detection Time • Heater delay time: t ~ 10 ms close to quench plateau;t < 15 ms at I = 62% Issl • Detection time: 3 - 11 ms during TQS01c training • Flux jumps up to 600 mV with MJR cable TQC01 msec TQS01c LQ Quench Protection – G. Ambrosio

  4. MIITs Limit • During TQC01 test, one QI vs. T measurement I: 5000 A , QI: 9.05 MIITs, Peak Temp: 340 K • Impact on quench performance of high-MIITs quenches (TQS01c) • + 4% after 8 MIITs • - 2.9% after 8.1 MIITs • - 7.4% after 8.7 MIITs • - 18.4 after 9.5 MIITs • Small bumps at 7.5 MIITs LQ Quench Protection – G. Ambrosio

  5. MIITs and Voltage at quench current Dump = 60 mWDetection time = 5 ms Heater delay time = 12 ms High MIITs at 1.9K Voltages OK LQ Quench Protection – G. Ambrosio

  6. Needs for LQ QP • Four independent circuits for protection heaters • Change dump resistance at 1.9K? • Easily changeable detection threshold • Develop smart quench detection to avoid spikes with low threshold? • Time • Voltage slope • Spike recognition • Current depending threshold • … LQ Quench Protection – G. Ambrosio

  7. Spikes in TQS02 LQ Quench Protection – G. Ambrosio

  8. 4.5 – 1.9 K LQ Quench Protection – G. Ambrosio

  9. Threshold profile LQ Quench Protection – G. Ambrosio

More Related