1 / 28

Resident Physics Lectures

Resident Physics Lectures. Fluoroscopic Imaging (year 1). George David Associate Professor of Radiology Medical College of Georgia. Early Fluoroscopy. Radiologist directly viewed fluorescent screen screen covered with lead glass for protection Low light levels

hibner
Download Presentation

Resident Physics Lectures

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Resident Physics Lectures Fluoroscopic Imaging (year 1) George David Associate Professor of Radiology Medical College of Georgia

  2. Early Fluoroscopy • Radiologist directly viewed fluorescent screen • screen covered with lead glass for protection • Low light levels • 10-30 minute dark adaptation required by wearing red goggles

  3. Human eye light receptors • rods (scotopic vision) • respond to very low light levels • night vision • peripheral vision • poor visual acuity • poor gray shade detection • cones (photopic vision) • high direct vision acuity • blind at low illumination levels

  4. Image Intensifiers • evacuated glass envelope • vacuum tube

  5. Image Intensifier x-rays ==> light • Input • X-rays • Output • Small viewing screen

  6. Image Intensifier Components • input phosphor • x-rays to light • photocathode • light to electrons • electrostatic focusing lens • steer those electrons • accelerating anode • speed up those electrons • output phosphor • electrons to light

  7. Input Phosphor x-rays ==> light • Cesium iodide (CsI) • CsI crystal needles perpendicular to substrate • minimizes lateral light diffusion or scattering • improves resolution • typical image tube resolution • 3 - 5 line pairs / mm

  8. Input Phosphor absorption • K-Edge of phosphors • CS ==> (36 keV) • I ==> 33.2 keV • well suited to average fluoro beam energy • 30 to 40 keV • absorbs ~ 2/3 of incident beam energy

  9. Photocathode light photons ==> electrons • attached to input phosphor • minimizes light diffusion • Photo-emissive metal • light causes emission of photoelectrons • # photoelectrons emitted proportional to incident light from input phosphor

  10. lenses + + + + - - Electrostatic Focusing Lens • Several electrodes plated to inside glass envelope • + voltage applied to electrodes • voltages determine magnification mode • focuses each point of input phosphor to a point on output phosphor • inverts & reverses image • Side-side • Top=bottom • Black-white

  11. Accelerating Anode • in neck of image tube • + 25 - 35 kV charge • accelerates electrons • faster electrons produce more light when they strike output phosphor

  12. Output Phosphor Output Phosphor electrons ==> light • Small viewable fluorescent screen • 0.5 - 1 inch diameter • converts electron’s kinetic energy to light • ~ 50 fold increase in # light photons over input phosphor

  13. - Output Phosphor • thin aluminum layer on back of output phosphor • prevents screen’s light from re-entering tube & reaching input phosphor Output Phosphor X Aluminum

  14. Output phosphor viewing • direct • uses lenses & mirrors • television • high quality closed circuit television chain

  15. Image Tube Parameters • Brightness Gain • ratio of II brightness to a “standard” screen • Conversion Factor • light output per radiation rate input • Deterioration over time • 10% decline in brightness / year typical • must increase patient exposure to get same light intensity

  16. II Gain (Intensification Factor) Output phosphor brightness--------------------------------------“standard” screen brightness • typically ~ 10,000

  17. II Gain (Intensification Factor) • Brightness gain = minification gain X flux gain • Minification gain • making image smaller also makes it brighter • Flux gain • acceleration of electrons toward output phosphor Electrons +

  18. 12” mag mode 9” mag mode Minification • Minification gain Area of (effective) input phosphor----------------------------------------- Area of output phosphor Larger imageMore magnificationLess minificationSmallergain Smaller image Less magnificationMore minificationLargergain

  19. Minification Gain • image brighter because output screen smaller than input screen • changes with magnification mode (9”, 6”, etc) • changes by about 2X for each mag mode • typically 81 for 9” mode (output phosphor about 1” diam) • 36 for 6” mode • 16 for 4” mode Highest magnification Lowest Minification gain Lowest magnification Highest Minification gain 6” 12” 9”

  20. Auto-Brightness • Generator senses image brightness and modulates beam intensity to hold brightness constant Lowest magnification Highest Minification gainLowest dose Highest magnification Lowest Minification gainHighest dose 6” 12” 9”

  21. Flux Gain • Caused by high + voltage of anode • acceleration of electrons in tube • Does not change with magnification mode • typical value ~ 50

  22. Light Meter Lead Contrast • Ratio of brightness at center of image with & without blocking center • typically 10:1 to 20:1

  23. Light Meter Lead Image Tube Contrast • degrades over time • depends on • collimation • tube properties • input phosphor photon absorption • output phosphor electron absorption • light backscatter from output phosphor to input phosphor

  24. Other II Characteristics • Lag • persistence of illumination after irradiation • insignificant for modern tubes • Distortion • Image intensifier has rounded bottom • Electron steering better in center than in periphery • unequal magnification • straight lines appear bent • pincushion effect

  25. Vignetting • loss of brightness in image periphery • caused by • periphery displayed over larger area of input screen • decreases brightness • poorer periphery focus

  26. 9 “ 6” Multi-Field Image Tubes • Dual, 3X, 4X field sizes common • Image focused by adjusting voltage on focusing electrodes (electronic lenses) • By law, collimators must cone in during mag operation • X-ray field should match imaged field

  27. 9 “ 6” Magnification • Advantages • Magnifies anatomy • improves spatial resolution • Disadvantages • smaller field of view • increased radiation intensity (but less tissue exposed) • decreased minification gain

  28. Digital Fluoroscopic Receptors Flat Panel Digital Technology Now used for angiography / cardiology and some portable C-arms No spatial distortion

More Related