1 / 28

X-ray Imaging Using Single Photon Processing with Semiconductor Pixel Detectors

X-ray Imaging Using Single Photon Processing with Semiconductor Pixel Detectors. The Origins. High energy physics: unambiguous reconstruction of particle patterns with micrometer precision low input noise due to tiny pixel capacitance. WA 97, RD 19 (CERN): 208 Pb ions on Pb target

verdi
Download Presentation

X-ray Imaging Using Single Photon Processing with Semiconductor Pixel Detectors

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. X-ray ImagingUsingSingle Photon ProcessingwithSemiconductor Pixel Detectors

  2. The Origins... • High energy physics: • unambiguous reconstruction of particle patterns with micrometer precision • low input noise due to tiny pixel capacitance WA 97, RD 19 (CERN): 208Pb ions on Pb target 7 planes of silicon pixel ladders; 1.1 M pixels Bettina Mikulec Vertex 2002, 8 Nov. 2002

  3. Electronics CMOS technology advances steadily; Moore’s law Sensors new materials to increase stopping power and CCE; main problem: inhomogeneities! Hybrid Pixel Detectors Bettina Mikulec Vertex 2002, 8 Nov. 2002

  4. if  Q > process signal Single Photon Processing • Quantum imaging • Example: photon counting  Q has to correspond to a single particle! Bettina Mikulec Vertex 2002, 8 Nov. 2002

  5. Quantum Imaging - Advantages • Noise suppression • high signal-to-noise ratio; dose reduction • low rate imaging applications • Linear and theoretically unlimited dynamic range • Potential for discrimination of strongly Compton scattered photons (for mono-energetic sources) or e.g. fluorescence X-rays • Energy weighting of photons with spectral sources possible • higher dose efficiency; dose reduction Bettina Mikulec Vertex 2002, 8 Nov. 2002

  6. Medical Imaging Detector requirements (sensor and electronics) depend on diagnostic X-ray imaging application. Example: mammography • spatial resolution 5-20 lp/mm • high contrast resolution (<3%) • uniform response • patient dose <3 mGy • imaging area: 18 x 24 (24 x 30) cm2 • compact and easy to handle • stable operation • no cooling • digital • cheap Moore and direct detection quantum processing sensors to be improved high DQE (sensor + q.p.) to be solved ??? Bettina Mikulec Vertex 2002, 8 Nov. 2002

  7. Medipix1 square pixel size of 170 µm 64 x 64 pixels sensitive to positive input charge detector leakage current compensation columnwise one discriminator 15-bit counter per pixel count rate: ~1 MHz/pixel (35 MHz/mm2) parallel I/O 1 m SACMOS technology (1.6M transistors/chip) Medipix2 square pixel size of 55 µm 256 x 256 pixels sensitive to positive or negative input charge (free choice of different detector materials) pixel-by-pixel detector leakage current compensation window in energy discriminators designed to be linear over a large range 13-bit counter per pixel count rate: ~1 MHz/pixel (0.33 GHz/mm2) 3-side buttable serial or parallel I/O 0.25 m technology (33M transistors/chip) Medipix1 / Medipix2 Bettina Mikulec Vertex 2002, 8 Nov. 2002

  8. 12249 m 13907 m Medipix1 / Medipix2 the prototype… the new generation! Bettina Mikulec Vertex 2002, 8 Nov. 2002

  9. Medipix1 Applications Examples: • Dental radiography • Mammography • Angiography • Dynamic autoradiography • Tomosynthesis • Synchrotron applications • Electron-microscopy • Gamma camera • X-ray diffraction • Neutron detection • Dynamic defectoscopy • General research on photon counting! Bettina Mikulec Vertex 2002, 8 Nov. 2002

  10. Applications Dynamic Autoradiography: (INFN Napoli): Mammography (INFN Pisa, IFAE Barcelona): Mo tube 30 kV; Medipix1; part of a mammographic accreditation phantom Medipix1; 14C L-Leucine uptake from the solution into Octopus vulgaris eggs (last slice in time: 80 min) Bettina Mikulec Vertex 2002, 8 Nov. 2002

  11. Applications Dental Radiography (Univ. Glasgow, Univ. Freiburg, Mid-Sweden Univ.): Sens-A-Ray commercial dental CCD system (Regam Medical) Medipix1 160 Gy 80 Gy 40 Gy Bettina Mikulec Vertex 2002, 8 Nov. 2002

  12. Medipix1 - SNR Pixel-to-pixel non-uniformities: optimum for counting systems: Poisson limit  N optimum SNR = N /  N determined SNR for Medipix1 taking flood fields (Mo tube) covering the entire dynamic range of the chip:  SNRuncorr(max.) ~30 using a flatfield correction  Medipix1 follows perfectly the Poisson limit! Red curve = Poisson limit SNRuncorr Bettina Mikulec Vertex 2002, 8 Nov. 2002

  13. SNRuncorr Medipix1 - SNR SNRuncorr • differences in the raw SNR, but with flat field correction the Poisson limit is ALWAYS reached • BUT: flat field correction dependent on energy spectrum! • working in over-depletion reduces charge sharing effects  flat field corrects mainly sensor non-uniformities! Bettina Mikulec Vertex 2002, 8 Nov. 2002

  14. Medipix1 Flat Field Studies 2 kinds of non-uniformities: ‘waves’ and fixed pattern noise 17 V detector bias (under-depleted) 35 V detector bias (fully depleted) ‘waves’ due to bulk doping non-uniformities raw image wrong flat field; inverse ‘waves’, BUT: single pixel inhomogeneities smeared out  fixed pattern noise! flat field corrected Bettina Mikulec Vertex 2002, 8 Nov. 2002

  15. 8 V 24 V 32 V 48 V 64 V 80 V 16 V 4 V 12 V Si Wave Patterns • vary detector bias voltage from under- to over-depletion • divide flat field map @Vbias with map @100 V Bettina Mikulec Vertex 2002, 8 Nov. 2002

  16. Si Wave Patterns Section of the correction map for different detector bias: • ‘waves’ move in under-depletion; stable in over-depletion • amplitude decreases with bias, but waves don’t disappear completely Remark: images can be corrected for these non-uniformities Bettina Mikulec Vertex 2002, 8 Nov. 2002

  17. Dose Optimization • Dose optimization for specific imaging tasks: example: accumulation of single X-ray signals during X-ray of an anchovy Bettina Mikulec Vertex 2002, 8 Nov. 2002

  18. Summary Medipix1 • The Medipix1 prototype chip allows to study the photon counting approach • Comparison to charge integrating systems turned out to be sometimes difficult due to the larger pixel size of Medipix1 • Most of the problems encountered were due to sensor non-uniformities (e.g. locally varying leakage currents) and bump-bonding quality • Medipix1 turned out to be a tool to study the attached sensor; even silicon sensors show non-uniformities • The flat field correction was intensively studied and allows to minimize the pixel-to-pixel variations down to the Poisson limit over the full dynamic range of the chip. The energy dependence of the flat field correction has to be further investigated. • The experience with Medipix1 lead to many improvements implemented in the Medipix2 ASIC. Bettina Mikulec Vertex 2002, 8 Nov. 2002

  19. Medipix2 Characterization • all the reported measurements were done using the electronic calibration (injection capacitor + external voltage pulse). • The 8 fF injection capacitor nominal value has a tolerance of 10%. • The dedicated Muros2 readout system had been used Bettina Mikulec Vertex 2002, 8 Nov. 2002

  20. Medipix2 Characterization adjusted thresholds ~110 e- rms unadjusted thresholds ~500 e- rms Bettina Mikulec Vertex 2002, 8 Nov. 2002

  21. Medipix2 Characterization • Threshold linearity in the low threshold range: Bettina Mikulec Vertex 2002, 8 Nov. 2002

  22. Medipix2 Characterization • threshold at 2 ke- • injection of 1000 pulses of 3 ke- • matrix unmasked Bettina Mikulec Vertex 2002, 8 Nov. 2002

  23. Summary of the Electrical Measurements Bettina Mikulec Vertex 2002, 8 Nov. 2002

  24. Conclusions • Miniaturization of CMOS technology allows for small pixel sizes and increased functionality. • A new single photon processing chip Medipix2 consisting of a 256 x 256 matrix of 55 m square pixels has been produced and successfully characterized. • The potential of quantum imaging for various applications is still far from being fully explored. • Quantum imaging in the medical domain: • rather complete systems are required to convince end users • MTF and DQE curves as well as comparative phantom images are necessary for approval (see e.g. FDA) • A lot of progress has been made to achieve large areas; as yet no satisfactory solution for most medical applications • There is a trend in some applications towards object characterization in addition to simple transmission images need energy information  colour X-ray imaging Bettina Mikulec Vertex 2002, 8 Nov. 2002

  25. ‘Wishlist’ sensors: high absorption efficiency and improved homogeneity reliable ASIC-to-sensor connections tiling: large areas without dead space ASIC: • small pixel size with charge sharing solutions (modern CMOS technologies!) • low-noise front-end with appropriate sensor leakage current compensation; sensitive to electron and hole signals • very fast front-end for time-resolved studies • a precise threshold above noise • a multi-bit ADC/pixel for energy information (optimum weighting!) • large dynamic range • …??? cost! Bettina Mikulec Vertex 2002, 8 Nov. 2002

  26. Medipix1 Flat Field Studies a phantastic tool to studysensor inhomogeneities… • vary detector bias voltage from under- to over-depletion • calculate corresponding flat field from flood images (1st row) • divide with correction map from 100 V detector bias data (2nd row) Bettina Mikulec Vertex 2002, 8 Nov. 2002

  27. Medipix1 Flat Field Studies Bettina Mikulec Vertex 2002, 8 Nov. 2002

  28. Medipix2 Characterization adjusted thresholds ~110 e- rms mean ~1100 e- spread ~160 e- rms unadjusted thresholds ~400 e- rms Bettina Mikulec Vertex 2002, 8 Nov. 2002

More Related