Download
slide1 n.
Skip this Video
Loading SlideShow in 5 Seconds..
CDT Department PowerPoint Presentation
Download Presentation
CDT Department

CDT Department

618 Views Download Presentation
Download Presentation

CDT Department

- - - - - - - - - - - - - - - - - - - - - - - - - - - E N D - - - - - - - - - - - - - - - - - - - - - - - - - - -
Presentation Transcript

  1. Graphic Communication Isometric Introduction CDT Department

  2. Isometric Views with Circles and Curves • Isometric Views are one of the forms of 3D views that you need to know about in the Standard Grade Graphic Communication course. • This type of drawing shows the length, breadth, and height of the object being drawn. • An isometric is drawn with a corner closest to the viewer. • All vertical lines and all lines angled back at 30º can be measured accurately. No other lines on Isometric views can be measured.

  3. Isometric Views with Circles and Curves • If you are sitting an SQA Credit paper in Graphic Communication, you will be required to know how to draw isometric views with curves. • This type of drawing is always included in the final paper each year. • The table on the following slide shows when each type of drawing was used and how many marks were allocated to it. • You will need to know how to draw full and part circles and also sloping edges and surfaces. • The ability to be able to answer questions about isometrics will be a great help in letting you reach the pass mark in the Credit exam paper. • If you are sitting the General paper you will need to know how to draw Isometric Views, although they will not normally include curves and circles, but will include sloping edges and surfaces.

  4. Isometric Views – Credit Paper

  5. Isometric Views - General