1 / 7

Current Progress

Current Progress. Thanks to help from Luis and Justin, I’m now getting results that seem reasonable. I’m happy to use more refined meshes (~1mm) and confident the results will be worth the computation time. Used energy250 file that Luis supplied, and 3mm mesh to create the collimator jaw.

Download Presentation

Current Progress

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Current Progress • Thanks to help from Luis and Justin, I’m now getting results that seem reasonable. • I’m happy to use more refined meshes (~1mm) and confident the results will be worth the computation time.

  2. Used energy250 file that Luis supplied, and 3mm mesh to create the collimator jaw. • Applied this as one bunch lasting 1ps, then 337ns later applied again as second bunch. Allowed this simulation to run until 6ms to see the effect of stress waves. • A rough calculation showed that 6ms was the approximate time a stress wave would take to reach the surfaces other than the nearest surface.

  3. Temperatures

  4. Node 3057 • Whilst looking for the maximum temperature for each load step it was found that node 3057 was always the hottest. • A graph was produced showing this nodes temperature against time. • Temperature rise for 2 bunches is double temperature rise for 1 bunch. • No time for heat to disperse through conduction. • Maximum temperature still lower than that predicted by Luis (~x-100).

  5. Node 3057 Temperature v. Time

  6. Stress • Maximum stress seem so far is of the order of 1MPa. • Does appear to be linear with temperature. • A stress wave does seem to travel down the taper which looks like a possible area of failure. • A avi file showing the simulation can be found here: http://www.eng-external.rl.ac.uk/ilc/022-2_bunches_long_iso.avi

  7. Von Mises Stress after 6ms

More Related