Project: IEEE P802.15 Working Group for Wireless Personal Area Networks        (WPANs)
Download
1 / 7

Project: IEEE P802.15 Working Group for Wireless Personal Area Networks (WPANs) - PowerPoint PPT Presentation


  • 80 Views
  • Uploaded on

Project: IEEE P802.15 Working Group for Wireless Personal Area Networks (WPANs) Submission Title: [Frequency Plan and PRF Proposal for TG4a] Date Submitted: [27 April 2005] Source: [Ismail Lakkis & Saeid Safavi, Wideband Access Inc.] Contact: Saeid Safavi.

loader
I am the owner, or an agent authorized to act on behalf of the owner, of the copyrighted work described.
capcha
Download Presentation

PowerPoint Slideshow about 'Project: IEEE P802.15 Working Group for Wireless Personal Area Networks (WPANs)' - matty


An Image/Link below is provided (as is) to download presentation

Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author.While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server.


- - - - - - - - - - - - - - - - - - - - - - - - - - E N D - - - - - - - - - - - - - - - - - - - - - - - - - -
Presentation Transcript
Project ieee p802 15 working group for wireless personal area networks wpans

Project: IEEE P802.15 Working Group for Wireless Personal Area Networks (WPANs)

Submission Title: [Frequency Plan and PRF Proposal for TG4a]

Date Submitted: [27 April 2005]

Source: [Ismail Lakkis & Saeid Safavi, Wideband Access Inc.]

Contact: Saeid Safavi.

Voice:[+1 858 642 9114, E-Mail: ssafavi@widebandaccess.com]

Abstract: [Minimum required PRF for CMOS DS-UWB radios]

Purpose: [Clarification of relationship between minimum PRF and maximum allowed voltage level in UWB IR]

Notice: This document has been prepared to assist the IEEE P802.15. It is offered as a basis for discussion and is not binding on the contributing individual(s) or organization(s). The material in this document is subject to change in form and content after further study. The contributor(s) reserve(s) the right to add, amend or withdraw material contained herein.

Release: The contributor acknowledges and accepts that this contribution becomes the property of IEEE and may be made publicly available by P802.15.


Impulse radio bpsk

PRI Area Networks (WPANs)

VPeak

TC

Impulse Radio-BPSK


Minimum prf requirements
Minimum PRF Requirements Area Networks (WPANs)


Benefits of low prf over high prf
Benefits of Low PRF over High PRF Area Networks (WPANs)

  • A Low PRF system has a lower implementation cost when compared to a high PRF system

  • Overall required receiver gain is lower for a Low PRF system. For example a 12 MHz PRF would reduce the receiver dynamic range by 7 dB when compared to a 60 MHz PRF

  • The ADC would run at 12 MHz instead of 60 MHz in the above example and the entire digital processor would run at a lower clock reducing the power by a factor of 5 in CMOS

  • Acquisition is easier to implement since with Lower PRF the sync matched filter is much smaller:

    • If a 12 MHz system requires a 64 pulses sync pattern, a 60 MHz system would require a sync of 320 pulses to achieve same SNR.

  • Since Energy per pulse is higher (7 dB in the above example), a non-coherent receiver would perform better.


Pll reference diagram
PLL Reference Diagram Area Networks (WPANs)

fX

fComp

Oscillator

Reference

Divider

(R)

output

XTAL

Phase Det.

LPF

VCO

Divider, N


Frequency plan
Frequency Plan Area Networks (WPANs)

Band No. 4

1

2

3

3

4

5

GHz

3.25

3.5

3.75

4.25

4.5

4.75

Note: This plan has equal margins to 3.1 GHz & 4.9 GHz frequencies


The prf
The PRF Area Networks (WPANs)

  • The basic recommended PRF is 13 MHz.

  • A PRF of 26 MHz is also supported.

  • These PRFs can be generated from the center frequencies of the supported bands. For example, a PRF of 13 MHz may be obtained by dividing the center frequencies by 268, 308, and 348 for bands 1, 2, and 3 respectively.

  • It is worth mentioning that ranging precision stays unchanged when using PRFs of 13 MHz and 26 MHz (or even higher PRFs) as the effective pulse width is only affected by bandwidth not the PRF.