1 / 6

Heat transfer in Lightsabers

Heat transfer in Lightsabers. An ME 340 Project by Clayton Grames. Introduction. Lightsabers are fictional weapons used in the Star Wars Universe Energy is focused through a crystal to form a beam of light that can cut through virtually anything

lindp
Download Presentation

Heat transfer in Lightsabers

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Heat transfer in Lightsabers An ME 340 Project by Clayton Grames

  2. Introduction • Lightsabers are fictional weapons used in the Star Wars Universe • Energy is focused through a crystal to form a beam of light that can cut through virtually anything • Lightsabers are traditionallythe weapons of Jedi Knights

  3. Objective • This project aims to find the maximum heat flux from the focus crystal that would maintain a safe constant outer surface temperature • Assumptions: • Constant heat flux through from the crystal radially outward • Liquid coolant in the crystal chamber negates the effects of radiative heat transfer • Crystal mounts are fully insulated

  4. conditions Insulation K = 0.2 W/m*K L = 15 mm • Convective heat transfer coefficients are found for the internal flow and the outer surface • The hydraulic internal flow is turbulent and causes free convection to be negligible • A thermal circuit is used to calculate the heat flux from the surface of the lightsaber to center of the crystal chamber Water V = 1 m/sTi = 300 K, k = 0.58 Water To = 400 K Al Housing K = 200 W/m*K L = 10 mm Ts = 300 K T∞ = 290 K

  5. Thermal circuit • This shows the thermal circuit used to calculate the heat flux through the system • Where: • Q = (Tsurface – Tinside)/Rtotal • The heat flux for the given assumptions was found to be very small • Q = 2.09 W/m^2 Water Cond. Rubber Insulation Outside Conv. Al Shell Water Convection with Wall and Crystal

  6. Calculations

More Related