1 / 13

Growth Behavior of Co on Al(001) substrate

Growth Behavior of Co on Al(001) substrate. Sang-Pil Kim 1),2) , Seung-Cheol Lee 1) , Kwang-Ryeol Lee 1) and Yong-Chae Chung 2) Future Technology Research Division, KIST, Seoul, Korea Department of Ceramic Engineering, Hanyang University, Seoul, Korea. Introduction. 1~2nm.

kara
Download Presentation

Growth Behavior of Co on Al(001) substrate

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Growth Behavior of Co on Al(001) substrate Sang-Pil Kim1),2), Seung-Cheol Lee1), Kwang-Ryeol Lee1)and Yong-Chae Chung2) Future Technology Research Division, KIST, Seoul, Korea Department of Ceramic Engineering, Hanyang University, Seoul, Korea

  2. Introduction 1~2nm Typical structure of spintronic device • The efficiency of spintronic devices (e.g. TMR, GMR ... ) are largely dependent on the electronic structure of the active layers, and electronic structures are closely related to both interface and thin film structures. • Research on interface or thin film structures in hetero-epitaxial growth • FCC/BCC  Ni on Fe(100), Cu on Fe(100), Fe on Al(100) … HCP/FCC, BCC/HCP  Co on Cr(100), Co on Mo(100) …

  3. Co Al 3ML Al on Co(001) 2.86 Å 4.05 Å 3ML Co on Al(001) Surface Alloying of Co on Al(001) Even when the incident energy of the Co atom was 0.1 eV spontaneous intermixing of Co and Al was observed*. Surface unit cell of Al(001) and B2-CoAl(001) have less than 0.1% lattice mismatch  Highly ordered surface alloying * S.-P. Kim et al., J. Appl. Phys., 93, 8564 (2003)

  4. Nonmagnetic behavior Magnetic behavior B2 - CoAl Magnetic Behavior of CoAl • B2-CoAl & Al-rich CoxAl1-x Nonmagnetic behavior • Co-rich CoxAl1-x Ferro magnetic behavior Al-rich Co-rich

  5. Motivation Al deposition Co substrate Al on Co substrate Co: Ferromagnetic CoAl: Nonmagnetic GMR structure Co: Ferromagnetic • Active intermixing & Nonmagnetic B2-CoAl for Co on Al substrate • Sharp interface & Layer-by-layer growth of Al for Al on Co substrate Investigate thin film growth behavior of Co films on CoAl

  6. z[001] y[010] x[100] Calculation Methods (001) Substrate Conditions • Embedded Atom Method Potentials for Co-Al system • x,y  Periodic Boundary Conditionz  Open surface (fixing the bottom-most two layers) • Substrate Temp. : 300K • Incident Energy with normal incidence 0.1 eV, and 3.0 eV • Time step : 1 fs 5000 fs (5 ps) / atom • Deposition rate:1.306 × 10-1 nm/nsec 1440 atoms (144atoms/ML) Substrate dimensions : (12  6  5)a0 a0 : bulk lattice constant

  7. Co Thin Film I 1~10ML: 0.1 eV incident E. of Co adatom 10~20ML: 3.0 eV 12 ML 15 ML 18 ML z[001] x[100]

  8. Size Effect Test (50×6×8)a0  9600 substrate Al atoms 15 ML 18 ML Same behavior! 20 ML

  9. Phase Transition Sinking due to the lattice mismatch A little moved to the one side ≈60° fcc-Co: 3.56 Å vs. Al: 4.05 Å HCP (11-20) Face centered tetragonal (FCT) A: HCP, B: FCT, C: B2(BCC)

  10. ~ 0.1 % 7.4 % larger than substrate z[001] x[100] Geometric Relationships Co CoAl Al

  11. Co Thin Film Growth II 1~20 ML: 0.1 eV, Sub. Temp.: 300 K 12 ML 15 ML 18 ML z[001] x[100]

  12. Schematic of Strain Energy Whole system Strain Energy Al substrate Co film HCP HCP+FCT FCT Co film structure

  13. Summary • Growth behavior of Co thin film on Al substrate by Molecular Dynamics simulation. • Co thin film was composed of two different hetero epitaxial grains of HCP and FCT structure. • The fraction of each grain seems to be determined by minimizing the total strain energy of both thin film and substrate.

More Related