1 / 8

Multimeters

Multimeters. How to use them. The Multimeter. We have black and yellow ones – the black ones are the ‘newest’… Some of the yellow ones have ‘use only as an ammeter’ written on them… look at such advice!. ‘COM’.

jeroen
Download Presentation

Multimeters

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Multimeters How to use them

  2. The Multimeter We have black and yellow ones – the black ones are the ‘newest’… Some of the yellow ones have ‘use only as an ammeter’ written on them… look at such advice!

  3. ‘COM’ • Always start by putting a wire into the ‘com’ connection – this is common to its use as a voltmeter and ammeter.

  4. Use as an ammeter • You already have one wire in the ‘com’. You need to put another wire in the terminal with ’10A’ on it • Then turn the dial to 10A

  5. Ammeter • The ammeter is placed in series in a circuit – never put it in parallel – it is of such low resistance that it will cause a short circuit and could make your power pack ‘blow’ or a battery get very hot! • You have to make a gap in your circuit to add it in. Put it next to the component you wish to investigate. • It tells you the rate at which the charge is moving through your component (how fast the charge is moving) • A ‘typical’ low current is 0.1A • A high current is anything more than 1A – 5A will make the wires smell and/or melt!

  6. Use as a voltmeter • You already have one wire in the ‘com’. You need to put another wire in the terminal with a V on it • Then turn the dial to 20V

  7. Voltmeter • The voltmeter is placed in parallel around the component you are investigating. Never put it in series – it has such a high resistance it will cut the flow of current down to a trickle! • It tells you the potential difference across the component – the ‘electrical slope’ that makes charge move through it. • It is always the last part of a circuit that you wire up and can be added or removed without changing the action of the circuit itself.

  8. Always turn the dial ‘off’ after use • These multimeters operate on 9V batteries. • They are expensive to run all day and night! • Make sure they are ‘off’ when you are not using them

More Related