html5-img
1 / 15

Project in jet engine OGV aerodynamics - Vane design

Project in jet engine OGV aerodynamics - Vane design. About me…. Working at the department of aerothermodynamics at Volvo Aero in Trollhättan. Studied at Chalmers, Master of science in chemistry and physics spring 2006.

hadassah-duke
Download Presentation

Project in jet engine OGV aerodynamics - Vane design

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Project in jet engine OGV aerodynamics- Vane design

  2. About me… • Working at the department of aerothermodynamics at Volvo Aero in Trollhättan. • Studied at Chalmers, Master of science in chemistry and physics spring 2006. • Master thesis about optimisation of a outlet nozzle using response surface methodology at Volvo. 7161, Sofia Ore

  3. Objective • Introduce Outlet Guide Vane (OGV) • Give introduction to vane design fundamentals 7161, Sofia Ore

  4. What is an OGV? • The OGV is situated behind the LPT. • It is a part of the rear structure. 7161, Sofia Ore

  5. Functions • Turn the flow to axial. • Load carrier since the rear engine mount is situated in the rear structure. • Oil pipes through some vanes implies constraints on their thickness. 7161, Sofia Ore

  6. Design goal • High engine thrust (low pressure loss) • Larger swirl angle out of the LPT => • Higher efficency in the LPT • Lighter engine because one stage in the LPT can be taken away. => large flow turning in the OGV 7161, Sofia Ore

  7. Designing an OGV 1. • Design cases: • On-design, Cruise • Off-design, ±10 degrees • In off-design conditions separation may occur which leads to increased pressure losses. • Most problematic area is the suction side, especially near the end-walls. 2. 7161, Sofia Ore

  8. Shroud Hub Designing an OGV • Start by designing a 2D vane at the midspan using given criterias such as: • tmax (oil pipes) • inlet boundary conditions (from the turbine) • inlet velocity • inlet angle • inlet pressure • pitch • span 7161, Sofia Ore

  9. Designing an OGV today Geometry generator Mesh in Gambit CFD calculations in Fluent 7161, Sofia Ore

  10. Designing an OGV • Check no separation at off-design • Make a 3D model and check the criterias. 7161, Sofia Ore

  11. The design process • CFD • Mesh and calculate the nine OGV • Optimisation • Find the best OGV from the ones you get • Experiment • Design a 3D model of the OGV including pressure taps • Manufacture • Validation 7161, Sofia Ore

  12. CFD-data Given data for CFD calculations: • Inlet angle = 30 degrees (on design) • Inlet velocity = 20 m/s • Outlet pressure = 101330 Pa 7161, Sofia Ore

  13. The designed test-facility 7161, Sofia Ore

  14. The designed test-facility Test rigg Vane 7161, Sofia Ore

  15. Thank you and good luck! 7161, Sofia Ore

More Related