1 / 18

Furnace Efficiency

Furnace Efficiency. Bryce Cox Dallin Bullock. Problem. My gas bill is very expensive My furnace claims an efficiency of 78% but it appears to be less efficient. Objective. Using recorded high and low temperatures calculate the heat flux from my apartment in the month of March 2008

fred
Download Presentation

Furnace Efficiency

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Furnace Efficiency Bryce Cox Dallin Bullock

  2. Problem • My gas bill is very expensive • My furnace claims an efficiency of 78% but it appears to be less efficient

  3. Objective • Using recorded high and low temperatures calculate the heat flux from my apartment in the month of March 2008 • Use information on gas bill to determine natural gas used for heating • Compare calculated use to measured and compare efficiencies

  4. Assumptions • Radiation is negligible • Furnace keeps temperature inside apartment a constant 70º F • All neighboring apartments also at constant 70º F • Heat transfer through only two walls

  5. More Assumptions • Average convective heat transfer coefficient of 10 W/m^2·K • Inside wall surface temperature is equal to temperature inside apartment

  6. Set up • Generate value for conductive resistance in walls • Find values for thermal conductivity of wall materials

  7. Solution • Total resistance ofcomposite wall is1.054 m^2·K/W • Resistance of windowsis 0.105 m^2·K/W

  8. Solution • From recorded high and low temperatures we estimated average day and night time temperatures • We then used the average temperatures to calculate heat flux for each day and night

  9. Results • We found the total energy lost by heat transfer for the month was 3,371,151,069 Joules • Converted to British Thermal Units: 3,195,234 BTU • 3.195 DecaTherms (Unit used by gas company)

  10. Results • My gas bill states that I used 7.2 decatherms in March. Estimating that 1.5 decatherms a month is used by the water heater and oven then 5.7 DTH were used by the furnace

  11. Results • The furnace has a published efficiency of 78% • According to our calculations this means the furnace should use 4.1 DTH • We found that it actually used 5.7DTH which is about 56% efficiency

  12. Conclusion • The discrepancy in efficiency is due to many possible factors: • Dirty filter • Restricted air flow (poor duct arrangement) • Dust buildup in combustion chamber

  13. Recommendations • Change filter every 3 months • Clean ducts if needed • Make sure vents are not obstructed

  14. Appendix • Resistance per area equations:

  15. Appendix • Heat transfer equation:

  16. Appendix • Thicknesses • Brick 102mm • Wood siding 8mm • Studs 130 mm(40 mm wide, .65 m apart) • Gypsum 12mm • Glass 7mm

  17. Appendix • Total wall area: 34.82 m^2 • Total window area: 5.63 m^2

  18. Appendix • References: • BYU Geography Department – Weather statistics • http://www.pgjr.alpine.k12.ut.us/science/james/provo2008.html • Trane Heating Systems – Furnace Information • http://www.trane.com/residential/products/Furnaces/XR80.aspx

More Related