1 / 15

GTP Scenario # 2

GTP Scenario # 2. September 17,2005. Scenario # 2. Dr. Good received IND approval for CD8 depletion of allogeneic PBMC for a Phase I/II clinical trial. Laboratory Information. Cell Therapy Laboratory: Unclassified facility. BSC cleaned with 10% bleach before use (1 product per BSC).

cortez
Download Presentation

GTP Scenario # 2

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. GTP Scenario # 2 September 17,2005

  2. Scenario # 2 • Dr. Good received IND approval for CD8 depletion of allogeneic PBMC for a Phase I/II clinical trial.

  3. Laboratory Information • Cell Therapy Laboratory: • Unclassified facility. • BSC cleaned with 10% bleach before use (1 product per BSC). • BSC is certified annually. • Depletion is performed in the general laboratory area (not within BSC). • Product sampling is performed in the BSC. • What level of EM and Cleaning is required?

  4. What should be considered? • Evaluate the conditions. • The process is ‘functionally closed’. • The product is a 351 IND product. • The laboratory in which the depletion process occurs is an unclassified room. • Other processing (sampling, antibody addition) occurs in the BSC.

  5. Product Monitoring • Sterility: Pre & Post processing? • Recommended • Periodic audit review of sterility results? • Recommended

  6. BSC Environmental Monitoring • Settle plates during processing? • Recommend as part of process validation. Determine need based on data. • Surface sampling after cleaning? • Perform as part of validation and as periodic check of cleaning procedure. • Airborne sampling during processing? • Not recommended.

  7. Facility Monitoring • Perform air particle counts during processing? • Recommend monthly checks during laboratory ‘working hours’ (dynamic monitoring).

  8. Personnel Monitoring • Perform on day of processing after the staff completes the process? • Recommend performing during processing only if products begin to have positive sterility results.

  9. EM & PM Result Review • How often? • Recommend monthly review. • Does this need to be done before product release? • Review cannot be part of product release; the product is infused immediately after processing (fresh).

  10. Cleaning • BSC? • Depletion Device? • Lab benchtops? • Lab floors? • Document Review?

  11. Cleaning Recommendations • BSC • Cleaning with 10% bleach before & after use. • Unless post-processing cultures become positive (investigation outcome).

  12. Cleaning Recommendations • Depletion Device & Benchtops: • Clean before & after use; Device using manufacturer’s instructions, Benchtop using 70% IPA. • Floors: • Clean on a periodic basis. • Unless post-processing cultures become positive (investigation outcome). • Unless there is a spill.

  13. Cleaning Document Review • How often? • Recommend periodic document review. • Does this need to be done before product release? • Review should not be part of product release.

  14. Variation # 1 • Would you do anything differently if the blood had to be ficolled in conical tubes before depletion? • Yes, refer to ‘open’ process recommendations.

  15. Variation # 2 • Would you change anything if this were a Phase III study? • No, unless required by the FDA.

More Related