1 / 4

Installing a VOR Antenna on Zenith’s “Flying Rudder” by Bill Bartlett

Installing a VOR Antenna on Zenith’s “Flying Rudder” by Bill Bartlett. Cutout hole using the antenna gasket as a template. Dill two holes to accommodate appropriate nut-plates or rivnuts. Deburr and smooth edges. Check antenna connections clearance with cut out.

Download Presentation

Installing a VOR Antenna on Zenith’s “Flying Rudder” by Bill Bartlett

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Installing a VOR Antenna on Zenith’s “Flying Rudder”by Bill Bartlett • Cutout hole using the antenna gasket as a template. • Dill two holes to accommodate appropriate nut-plates or rivnuts. • Deburr and smooth edges. • Check antenna connections clearance with cut out. • Antenna connections must not come in contact with the rudder. • Add a dielectric edge protection if required. • Or, coat your connections with electrician’s liquid tape. • I used a nut-plate for the forward hole; and, a rivnut for the aft hole. • 6T4-4 Vertical Tail Spar wouldn’t allow room for a nut plate.

  2. Installing a VOR Antenna on Zenith’s “Flying Rudder”by Bill Bartlett • VOR antenna installed on top 6T4-2 Tip Rib. • Close up view of “AN” bolts attaching the antenna to the Top Rib.

  3. Installing a VOR Antenna on Zenith’s “Flying Rudder”by Bill Bartlett • How it looks when the rudder is attached to the fuselage. • Coaxial cable is routed inside the leading edge skin.

  4. Installing a VOR Antenna on Zenith’s “Flying Rudder”by Bill Bartlett • Coaxial cable is routed through the 6T4-1 Nose Rib. • Add grommet to hole through the nose rib. • I placed a small clear tube around cable to help protect the cable fit the clamp.

More Related