1 / 14

Concrete Formwork

Concrete Formwork. General Requirements Safe – must hold concrete in place until cured. Economical provide desired shape and surface texture Formwork usually cost more than the concrete. Typical formwork Can be wood Steel Aluminum

chanel
Download Presentation

Concrete Formwork

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Concrete Formwork

  2. General Requirements • Safe – must hold concrete in place until cured. • Economical • provide desired shape and surface texture • Formwork usually cost more than the concrete

  3. Typical formwork • Can be • wood • Steel • Aluminum • Must be braced to withstand load (concrete weighs 150pcf)

  4. Wall form F 11-18 • Double wales used above and below ties to allow tie to be secured • Also need a spreader to keep forms correct distance apart • Need to have good bracing at foot of form • Ties F 11-19 • Most common can be broken off just inside concrete – allows for patching

  5. Column Forms • Use column clamps for support/bracing • May have windows to making pouring easier • F 11-20 • Slabs • F 11- 21 -> 11-25

  6. Construction Practices • Forms need tight joints • Forms need to be aligned and checked for alignment during pour • Don’t forget uplift on some types of forms • Don’t drop concrete more than 5’ • Don’t vibrate previously poured concrete too deeply – could cause form failure • Carefully remove forms – don’t want surface damage

  7. Expansion and control joints • Permit differential movement in concrete shapes • Concrete shrinkage, temperature change, moisture change, settlement • Isolate interior columns from floor slab – cut around column

  8. Formwork safety • Pg 321

  9. Reinforcing Steel • Reinforcing bars • Usually deformed (manufactured with ridges to increase bond with concrete) • Can be plain or epoxy coated • Sized by 1/8th inch and strength of steel • T 11-1, F 11-28

  10. Reinforcing Steel • Welded wire fabric • Common for slabs • Smooth or deformed wire • WWF is identifier • WWF 6x6-4.0x4.0 is a welded wire fabric with 6 inch spacing longitudinally and transversely made of W4 size (0.04 x section area) wire

  11. Spirals (for columns) • 3 standard sizes 3/8 inch, ½ inch, 5/8 inch diameter rods • Sprial diameters (outside to outside) 12” minimum to 33” max • Pitch from 1.75” – 3.25” (distance from center to center of rod)

  12. Placing Reinforcing • Rebar goes in areas of tension • F 11-29 • Need to protect rebar from corrosion fire and weather • Pg 325 gives min cover • Minimum clear distance between parallel bars in columns = 1.5” or 1.5 x max aggregate size • For other shapes 1” or 1.333 x max aggregate size

  13. Placing Reinforcing • Rebars kept in place by ties • F 11-30, 11-31

  14. QC • Common deficiencies • Pg 329 • Inspection and Testing • Usually concrete is a fast paced activity • Need to inspect product from stockpile to placement and then test for strength, air entrainment, beam flexure

More Related