1 / 8

GY403 Structural Geology Lab

GY403 Structural Geology Lab. Thickness and Depth Problems. Special Case: horizontal attitude. Note: geological contacts will parallel topographic contour lines on map. 93 ft. 87 ft. T=93-87 = 6 ft. Thickness (t) = Elev. Upper contact – Elev. Lower contact. Special Case: vertical attitude.

cachez
Download Presentation

GY403 Structural Geology Lab

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. GY403 Structural Geology Lab Thickness and Depth Problems

  2. Special Case: horizontal attitude Note: geological contacts will parallel topographic contour lines on map. 93 ft. 87 ft. T=93-87 = 6 ft. Thickness (t) = Elev. Upper contact – Elev. Lower contact

  3. Special Case: vertical attitude Note: cross-section is perpendicular to strike of unit. Thickness = outcrop width in this case. w General Rule: If the dip (δ) of the unit is perpendicular to the ground surface then w = t. δ t

  4. NOTE: cross section is perpendicular to strike of strata w= true outcrop width δ t= true thickness

  5. Cos = (w) / (w’) β * (w’) w = Cos β w’ = apparent outcrop width N β 40 w = true outcrop width 40

  6. West East Scenario: slope and dip are inclined in opposite directions w West-facing slope σ δ t δ = true dip angle σ = slope angle Sin( δ + σ ) = t/w t = Sin( δ + σ ) * w Note: cross-section must be perpendicular to strike of bedding

  7. West East East-facing slope Scenario: slope and dip are inclined in same direction w δ = true dip angle δ - σ σ = slope angle σ t δ Sin( δ - σ ) = t/w t = Sin( δ - σ ) * w Note: cross-section must be perpendicular to strike of bedding, and slope angle ( ) must be measured perpendicular to strike. σ

  8. NOTE: cross section is perpendicular to strike of strata w= true outcrop width δ δ t d= depth in vertical drill hole Cos ( δ ) = t / d δ d = t / Cos( )

More Related