1 / 19

LINK2000+ European ATS Provider Benefits Real-time Simulation Results

LINK2000+ European ATS Provider Benefits Real-time Simulation Results. ATN2002 Conference London, 24-25 September 2002. Rod McGregor. LINK2000+ Programme Datalink Implementation for Europe 2002-2007 Services selected because of identified effective operational benefits

bondc
Download Presentation

LINK2000+ European ATS Provider Benefits Real-time Simulation Results

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. LINK2000+ European ATS Provider Benefits Real-time Simulation Results ATN2002 Conference London, 24-25 September 2002 Rod McGregor

  2. LINK2000+ Programme • Datalink Implementation forEurope 2002-2007 • Services selected because of identified effective operational benefits • Implementation at centres andairports where the need exists • Affordable infrastructure - ATN over VDL2 (exploiting airline investment)

  3. LINK2000+ Real-time Simulation Project • followed other datalink projects such as EATCHIP IIIb/EOLIA and PETAL IIe • concentrated on operational aspectsnot technical aspects of datalink implementation • focused on an early implementationand non-time critical datalink services that had been previously evaluated • explored the implementation of datalink from the controllers perspective • developed acomplex real-time datalink simulator to replicate ATN datalink functionality

  4. Simulation Conduct • Conducted at the EUROCONTROLExperimental Centre near Paris • Involved project teams from theAix-en-Provence and Rome ATCCentres, as well as the EEC and the LINK2000+ Programme • A major effort for the EEC with over50 individuals committed to thesystem build and experimental conduct • Used operational controller teams to provide authentic feedback on the use of datalink in future datalink scenarios

  5. LINK2000+ Experiment Objectives • Confirm the feasibility of conducting voice and datalink in a mixed-mode environment • Determine good practice when considering datalink over voice (and vice-versa) • Identify potential changes to controller working methods • Identify ATC Procedures required for datalink operations • Assess the safety implications of non-nominal situations • Define the need for improvements to the datalink interface • Assess the operational and technical response times √

  6. Real-time Simulation • February 2002, 3weeks including training and measured exercises (28 measured exercises of 1 hour) • 14 Controllers (7 from Aix-en-Provence and 7 from Rome) • Traffic based on busiest regional dayin 2001(plus 10% and 25%) • Airborne datalink equipage at0%, 25% and 50% (representingthe implementation period) • Scenarios1 - Nominal (variation in traffic and datalink equipage)2 - PC Transfer (routine transfer task moved to the PC)3 - ACM Monitor (datalink aircraft did not check on frequency)4 - Non-Nominal (degradation of performance)

  7. NW BAW1234 290 350 350 BEKOS h045 m81 r25 • LINK2000+ Controller Interface (Two Controllers per sector each with a 28” screen) • No ‘Paper’ Flight Strips • Interactive Aircraft Label with 3-Button Mouseas sole input device (no keyboard) • Extensive use of colour coding • SYSCO silent electronic co-ordination • Graphical and list display of flight data • Safety Nets and System Reminders • Integrated datalink functionality with messages represented in track labels and Message In/Out windows

  8. LINK2000+ Datalink Implementation • DLIC - Datalink Initiation Capability - (between Equipped and Non-Equipped ATC Centres) • ACM - ATC Communication Management - Silent transfer of Data Authority and Aircraft Frequency Change Instructions, with indication that the Aircraft was ‘Monitoring’ the new frequency • AMC - ATC Microphone Check - Via simulated “Stuck Microphone” message to all aircraft • ACL - ATC Clearances – including Cleared Flight Level, Heading, Direct Route, Speed, and Rate of Change

  9. LINK2000+ Datalink Implementation • LACKS - Logical Acknowledgements– for all messages (defined timeouts for LACK response, Operational Response and Standby Offset) • Delay Value based on fixed (6 second) delivery time and defined Failure Rates for datalink messages • Pseudo-pilot responses to uplinked messages including WILCO, STANDBY, UNABLE, and scripted downlinks of REQUEST DIRECT and REQUEST LEVEL

  10. Datalink Benefits • Real-time Simulation Analysis • Subjective analysis based on: • Simulation Observation • Controller Debriefing Sessions • Questionnaires (Pre-simulation,Exercise, and End of Simulation) • Controller Workload Recordings • Supported by objective analysis based on recorded system data (including time-stamped HMI actions and datalink messages)

  11. During the experiment • 1953flight hours recorded for all sectors over the measured exercises • Sector throughput (1 hour) from50 - 108(depending on sector) • Maximum number of aircraft on frequency ranging from 18 - 35aircraft • 424 Pilot datalink requests downlinked to the controllers • 2719Controller instructions uplinked to simulated datalink aircraft

  12. Results - Controller comments • The Air/Ground concept was easy to understand • Air/Ground datalink procedureswere easy to work with • Using Air/Ground datalink reducesroutine communication tasks • It was not difficult to decide whento use datalink or voice tocommunicate • It was easy to learn to work with the Air/Ground datalink

  13. Results - General • Voice channel occupancy significantly reduced • 0% Datalink (39%) • 25% Equipage - 32% (-18%) • 50% Equipage - 26% (-33%) • Further gains (35%-50%) when combined with datalink aircraft ‘Monitoring’ not calling on frequency

  14. Results - Working Method • Controllers took less than 3 weeks to integrate datalink in to a new effective working method • Two separate control techniques developed for Datalink and Non-datalink aircraft (as non time-critical messages could become time-critical) • CPDLC clearances were (apparently) less suited to highly tactical environments (controllers reported two minutes required for action)

  15. Results - Task Reallocation • Planning Controller must be active (focussed on the screen) notpassive as today • ACM with PC Transfer withDatalink Aircraft Monitoringwas reportedly very successful • ACL service more complex totransfer clearance tasks to the PCdue to issues of control responsibility, teamwork, and situational awareness

  16. Results - Controller Interface • Clear distinction between equipped and non-equipped aircraft essential • Equally efficient HMI inputs for both equipped and non-equipped aircraft required • Revert-to-voice procedure and system update, in case of datalink error (DLError or No Reply) as short as possible • History of datalink messages required to support better team situational awareness

  17. Results Time-outs and Response Times • Timeouts for LACK response and No Reply as short as possible (30 seconds and 60 seconds) • Mean controller response time to a pilot request was 40 seconds (including delivery time) • (Pseudo-pilot response time was 25 seconds) • Controller composition times for datalink messages 75% less than 2 seconds and 99.5% less than 10 seconds (EATCHIP III datalink interface) • Non-nominal degraded datalink performance had little impact for controllers (due non-time critical use)

  18. Summary - ATS Provider Benefits • Results suggest that a safer, more efficient, ATM system through Datalinkimplementation is achievable • Effective R/T reduction and task re-distributionwas demonstrated “With datalink it should not be a problem if you never talk to an aircraft the whole time it is in your sector” • Next - further interface improvements andmore research into teamwork and situational awareness issues • Finally, datalink was shown to have the potential to revolutionise ATM, perhaps enabling change as radical as the introduction of radar

  19. Contacts • Rod McGregor - LINK2000+ RTS Project Manager (EEC) roderick.mcgregor@eurocontrol.int • Alex Wandels – LINK2000+ Programme Manager (Brussels) alex.wandels@eurocontrol.int • Chris Brain – LINK20000+ Operational Issues (Brussels)christopher.brain@eurocontrol.int • Martin Adnams – Implementation Issues (Brussels)martin.adnams@eurocontrol.int • References • LINK2000+ Real-time Simulation Report - September 2002 (EUROCONTROL Experimental Centre Report)

More Related