1 / 8

Look the calibration to understand what and when has been changed

Look the calibration to understand what and when has been changed in our electronics A. Maslennikov, 26 February 2010, HiLum workshop. November 08 logbook: 11.11.2008 - 14:30 J.F.: Following Evgeny, for MEDIUM gain 10 Ohm SMD resistors were

aggie
Download Presentation

Look the calibration to understand what and when has been changed

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. Look the calibration to understand what and when has been changed in our electronics A. Maslennikov, 26 February 2010, HiLum workshop November 08 logbook: 11.11.2008 - 14:30 J.F.: Following Evgeny, for MEDIUM gain 10 Ohm SMD resistors were soldered to 50 Ohm SMD resistors on front-end board resulting into 8.33 Ohm. As the consequence the gain for MEDIUM gain should be increased. LOW gain untouched. In fact, the transition has taken place between 18 April and 07 November 2008, see next slides.

  2. HEC shape - 18 April 2008 (gen 109, ch1:2, DAC= 5 000 top, 50 000 bottom)

  3. EMEC shape - 18 April 2008 (gen 117, ch1:2, DAC= 5 000 top, 50 000 bottom)

  4. HEC shape - 07 Nov 2008 (gen 109, ch1:2, DAC= 5 000 top, 50 000 bottom)

  5. EMEC shape - 07 Nov 2008 (gen 117, ch1:2, DAC= 5 000 top, 50 000 bottom)

  6. Next major intervention was in September 09 (two slides from E. Ladygin, HiLum meeting 21 Sept 09)FEB’s • burned board has been repaired • second board has been prepared • fuses & zener diodes have been installed on both boards Photo Next slide Question (A.M.): may these Zener diodes provoque the wiggles ?

More Related