1 / 19

Oblivious Routing for Wireless Mesh Networks by Jonathan Wellons and Yuan Xue

Oblivious Routing for Wireless Mesh Networks by Jonathan Wellons and Yuan Xue Presented by: Golnar Bidkhori. Introduction Model Problem Formulation. I. Introduction

abena
Download Presentation

Oblivious Routing for Wireless Mesh Networks by Jonathan Wellons and Yuan Xue

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Oblivious Routing for Wireless Mesh Networks by Jonathan Wellons and Yuan Xue Presented by: GolnarBidkhori

  2. Introduction • Model • Problem Formulation

  3. I. Introduction • Wireless mesh networks have attracted increasing attention and deployment as a high-performance and low-cost solution to last-mile broadband Internet access. • Proposed approaches for traffic routing usually fall onto two ends of a spectrum. - Heuristic routing algorithms - theoretical studies that formulate mesh network routing as optimization problems

  4. II. Model A. Network and Interference Model • We use w ∈ W to denote the set of gateways in the network • s ∈ S to denote the set of local access points that generate traffic in the network. • local access points, gateways and mesh routers are collectively called mesh nodes and denoted by the set V .

  5. All mesh nodes have the uniform transmission range denote by RT. • We denote the interference range of a mesh node as RI= (1 + Δ)RT, where Δ ≥ 0 is a constant. • r (u, v) is the distance between u and v (u, v ∈ V ).

  6. Packet transmission from node u to v is successful, if and only if (1) the distance between these two nodes r(u, v) satisfies r(u, v) ≤ RT. (2) any other node w ∈ V within the interference range of the receiving node v, i.e., r(w, v) ≤ RI, is not transmitting. • If node u can transit to v directly, they form an edge e = (u, v).

  7. The capacity of this edge is denoted as b(e) which is the maximum data rate. • Let E be the set of all edges. • We say two edges e, e ‘ interfere with each other, if they can not transmit simultaneously based on the protocol model. • Interference set I(e) contains the edges that interfere with edge e and e itself • w∗ represent the internet. w∗ is connected to each gateway with a virtual edge e∗ = (w∗, w). • E is the union of E and the set of all virtual edges and V is the union of V and the virtual node w∗.

  8. B. Traffic Demand and Routing • The aggregated traffic to a local access point is denoted as a flow. • All flows will take w* as their source. • ds is the traffic demand from local access point s ∈ S to w∗. • vector d = (ds, s ∈ S) denotes the demand vector consisting of all flow demands

  9. A routing specifies how traffic of each flow is routed across the network. • Arouting can be characterized by the fraction of each flow that is routed along each edge e ∈ E. • fs(e) denotes the fraction of demand from local access point s that is routed on the edge e ∈ E. • A routing can be specified by the set f = {fs(e), s ∈ S, e ∈ E}.

  10. The demand of node s ∈ S is denoted by ds. • The amount of traffic demand from s that needs to be routed over e under routing f is ds fs(e).

  11. C. Schedulability • y = (y(e), e ∈ E) denotes the wireless link rate vector, where y(e) is the aggregated flow rate along wireless link e. • Link rate vector yis said to be schedulable, if there exists a stable schedule that ensures every packet transmission with a bounded delay.

  12. Sufficient condition for schedulability. Claim 1. The link rate vector y is schedulable if the following condition isthe satisfied: ∀e ∈ E, <= 1

  13. III. PROBLEM FORMULATION • A common routing performance metric with respect to a known traffic demand is resource utilization. • In a multi hop wireless network, such as mesh backbone network, wireless link utilization may be inappropriate as a metric of routing performance due to the channel interference.

  14. A. Mesh Network Routing Under Known Traffic Demand • Let ys(e) be the traffic of s that is routed over e ∈ E. Obviously the aggregated flow rate ye along edge e ∈ E is given by ye =∑s ∈ S ys(e).

  15. Let y’s(e) be the traffic of s on edge e under traffic demand ds. Then y’s(e) = f s(e) .ds • Formally, we define the congestion of an interference set I(e) using its utilization and denote it as ρ(e). • we define the network congestion ρ = maxe∈ Eρ(e) as the maximum congestion among all the interference sets I(e). The congestion minimization routing problem is then formulated as follows:

  16. B. Oblivious Mesh Network Routing • ρ(f, d) is the network congestion under a certain routing f and traffic demand vector d • An optimal routing fopt(d) for a certain demand vector d would give the minimum congestion

  17. The performance ratio γ(f, d) of a given routing f on a given demand vector d is define as the ratio between the network congestion under f and the minimum congestion under the optimal routing. • Let D be a set of traffic demand vectors. • A routing f optis optimal for the traffic demand set D if and only if f opt= argminfγ(f,D) • PO: minimize ρ given ∀d with ρopt(d) = 1 Equations (1) - (6) from PCare true

More Related