slide1 l.
Download
Skip this Video
Loading SlideShow in 5 Seconds..
Our Quasi-Broadband Home PowerPoint Presentation
Download Presentation
Our Quasi-Broadband Home

Loading in 2 Seconds...

play fullscreen
1 / 48

Our Quasi-Broadband Home - PowerPoint PPT Presentation


  • 264 Views
  • Uploaded on

Our Quasi-Broadband Home Dave’s PC Sandy’s PC Card scanner and camera Rex interface Sandy’s portable The old 386 Scanner The server room The Plumbing – router and hubs Master LAN patch panel Attic plumbing Our NT server Fax machine Four-line phone Telephone and modem wiring

loader
I am the owner, or an agent authorized to act on behalf of the owner, of the copyrighted work described.
capcha
Download Presentation

PowerPoint Slideshow about 'Our Quasi-Broadband Home' - Olivia


An Image/Link below is provided (as is) to download presentation

Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author.While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server.


- - - - - - - - - - - - - - - - - - - - - - - - - - E N D - - - - - - - - - - - - - - - - - - - - - - - - - -
Presentation Transcript
slide28

A. Lower the Screen

  • On the switch panel (under thermostat near bar) find the screen switch on the upper left. Push to lower the screen. It will stop automatically when the screen is fully lowered
  • B. Turn on the VCR
  • Find the VCR remote control (it’s labeled “RCA” on the bottom). Push the red VCR1 button to power on the RCA VCR (the upper VCR on the left). The VCR is on if you see the channel number on the right of the VCR display (the time is displayed on the left whether the VCR is on or off).
  • C. Turn on and set up the Receiver
  • Find the receiver remote control (it’s labeled “Denon” on the upper left). Push the red POWER button to turn on the receiver (upper box on the right). The receiver is on if you see the display lit up.
  • Select VCR1 as receiver input device: If VCR1 is not shown on the receiver display, push the yellow VCR1 button (number “5”) on the receiver remote control. After a few seconds, you should hear sound from the loudspeakers if a video channel has been selected.
  • Set receiver mode to STEREO - push blue STEREO button on the remote control.

Instructions for turning it on

slide29

D. Turn on the Projector

  • Remove the lens cap from the projector (if it is on).
  • Plug in the projector if the line cord is disconnected (at the right rear).
  • Turn on the projector - the switch is just above the line cord at the rear of the projector. The projector will warm up in about a minute. You will first see a test pattern, and then the video picture corresponding to the sound. If you see a blue screen without a picture, open the control door on the top right of the projector, and push the VIDEO button. You should now see the picture.
  • E. (During daytime) Lower the Shades
  • The room is set up with six room darkening shades. Lower them to block out the sunlight.
  • F. To Change the Channel
  • Use the cable box remote control to change the channel. Push the white CABLE button on the top of the remote control, and then push the channel number. Note that all channels are three-digit numbers; use 004 for channel 4.

Instructions for turning it on - 2