DIY Project To Design a PCB to Control a Multi-directional Bot

1. DIY Project To Design a PCB to Control a Multi-directional Bot In our last video, we showed you how to design your custom multi-directional bot. If you haven’t seen it yet, click here. Today, we will how you can design a PCB to control a multi-directional Bot. Let’s start with the multi-directional bot’s circuit. This will ensure that the circuit is permanent with no loose wires! It is recommended to not perform this if you are less than 16. Components Required: 1) A Veroboard – Its also called Perf-Board / Zero-PCB 2) (25W+) Soldering Iron & Flux-Core Solder Wire 3) 1 Piece of ULN2803 IC 4) 2 Piece DIP Switches 5) 9V Battery & Battery Socket 6) Robot Chassis with 2 BO Motors & 2 Wheels Steps to Follow 1) Working of the system 2) Overview of the components Place ULN2803 IC, which is responsible for driving the BO Motors into the Veroboard. Then solder the pins.

2. Prototype the ground and VCC Channels, the system requires a stable system of power traces. So be very careful and observe. Inspect the board carefully, plan how the component and traces are to be connected. Watch the full video:https://youtu.be/2h14CxLfcfc You can read the full content: https://www.businessupside.com/2021/01/05/diy-project-to-design-a-pcb-to-control-a-multi- directional-bot/ •••••••••••••••••••••• BusinessUpside Email ID: support@businessupside.com Phone No.: +1-425-605-0775 Visit Us: https://www.businessupside.com/ Stay Connected Via: https://www.facebook.com/businessupside https://www.youtube.com/channel/UCuSkeS5oU-B2tRIBDYntmaw https://twitter.com/BusinessUpside1