1 / 10

Towards IEEE802.11 HDR in the Enterprise

Towards IEEE802.11 HDR in the Enterprise. Sebastien Simoens, Amitava Ghosh, Alistair Buttar, Karine Gosse, Ken Stewart Motorola Contact: simoens@motorola.com alistair.buttar@motorola.com. Future Enterprise. Enterprise data needs will continue to grow

zurina
Download Presentation

Towards IEEE802.11 HDR in the Enterprise

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Towards IEEE802.11 HDRin the Enterprise Sebastien Simoens, Amitava Ghosh, Alistair Buttar, Karine Gosse, Ken Stewart Motorola Contact: simoens@motorola.com alistair.buttar@motorola.com

  2. Future Enterprise • Enterprise data needs will continue to grow • Ethernet LANs will use 1Gb/s and 10Gb/s technologies in 2005 • Deployment of WLAN APs will complement wireline and cellular infrastructure • Peak data rate of >100Mb/s is attractive to IT departments (alternative to 100Base-T) • Higher peak data rates and higher average throughput result in productivity enhancements in the enterprise • Market trends support HDR standardization effort

  3. HDR Requirements • Extend 802.11a in the 5GHz band • Peak data rate >100Mb/s, and increased cell throughput • Broad regulatory support • Graceful degradation as the system load increases • Backwards compatible with 802.11 • Support for limited mobility • Optimized PHY/MAC solution • More efficient MAC enables to take advantage of higher rate PHY (see « WNG requirements for Home networking »)

  4. Technology Considerations • Advanced channel coder, e.g. Turbo Codes or Turbo Trellis Coded Modulation • OFDM but with higher order QAM (e.g. 256) and higher number of sub-carriers • Hybrid ARQ • Spatial Diversity Techniques e.g. 2x2 MIMO • Link Adaptation (already supported) • Reduced Overhead / Improved Signalling • Efficient QoS support • Improved performance can also be traded-off for lower power consumption, or increased robustness

  5. Improved Channel Coder • Use low constraint length Turbo Code eg. (K=3) R=1/3 instead of current K=7 R=1/2 convolutional code • Limit the number of iterations to 4 to reduce complexity at the terminal • 1-3dB gain can be achieved with Turbo codes compared to convolutional code

  6. Hybrid ARQ • Self-optimizing and adjusts automatically to channel conditions • Adds redundancy only when needed • Receiver saves failed transmission attempts to help future decoding • Every transmission helps to increase the packet success probability • HARQ Scheme should support both Incremental Redundancy (IR) and Chase Combining • Enabled by N-Channel Stop-and-Wait ARQ • AT-assisted Channel Quality Indication (CQI) • Channel reciprocity needs to be considered here, although potential differences in UL/DL interference levels. • Key Challenges • Can be best accommodated using optimized MAC • Memory cost at the terminal needs to be optimized

  7. 2x2 Spatial Diversity (1/3) • 2 Transmit, 2 Receive antenna system • Already addressed in other standards (802.16.3, 3GPP) • Improves peak data rate and/or average data throughput • Reasonable additional complexity • Many alternatives to exploit the 2x2 configuration: • link budget/cell throughput improvement relying on spatial diversity: Tx space-time block coding, Rx diversity • bit-rate increase with parallel data flows: Multiple Input Multiple Output techniques (MIMO) can be considered • « Beamforming » with channel knowledge at Tx: most gain obtained but requires feedback channel or TDD channel reciprocity assumption • Need for comparisons in terms of overall cell throughput • Need for defining the level of acceptable complexity at AP and MT

  8. 2x2 Spatial diversity (2/3) QPSK, 16QAM rate ½ code Packets: 2x54 bytes Space-Time Block Coding on .11a PHY, office NLOS channel 2x2 8.7dB 1x1 2x2 shows a significant improvement of 8.7dB at PER=10-2

  9. 2x2 Spatial diversity (3/3) Based on previous slide PHY results, with path loss (n=3.8) and shadowing 10.5Mb/s A significant cell range extension can be obtained 18Mb/s 29m

  10. Conclusion • Goal of HDR is to improve peak as well as the average throughput • Technology elements exist for efficient HDR WLAN • Standardization activity should be started before proprietary products fragment the marketplace • HDR Study Group should be created in 802.11

More Related