1 / 6

FIREPROOF AND FIRE RESISTANT MATERIALS

FIREPROOF AND FIRE RESISTANT MATERIALS. Federal Aviation Administration Project Manager: J. Reinhardt William J. Hughes Technical Center Airport and Aircraft Safety Research and Development Division Atlantic City International Airport, NJ. PURPOSE.

tellier
Download Presentation

FIREPROOF AND FIRE RESISTANT MATERIALS

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. FIREPROOF AND FIRE RESISTANT MATERIALS Federal Aviation Administration Project Manager: J. Reinhardt William J. Hughes Technical Center Airport and Aircraft Safety Research and Development Division Atlantic City International Airport, NJ

  2. PURPOSE • An ARAC Subcommittee is looking at revising AC25-135 (Powerplant Installation and Propulsion System Component Fire Protection Test Methods, Standards, and Criteria) • Develop a means to comply with the AC in order to evaluate various test specimens to determine whether they may be classified as: • Fireproof • Fire Resistant • Determine the feasibility of the testing methods performed.

  3. Current Proposed Procedure • CALIBRATION OF THERMOCOUPLES • Preheat Burner for 2 minutes. • Place Flame on Thermocouples for 90 seconds. • All Thermocouples must read 2000°F +/- 150°F .

  4. Current Proposed Procedure • CALIBRATION OF CALORIMETERS • Preheat Burner for 2 minutes. • Place Flame on Calorimeters for 90 seconds. • All Calorimeters must read above 10 BTU/(ft²·sec ) .

  5. Current Proposed Procedure • BURNER TEST • Preheat Flame for 2 minutes. • Place Flame for 16 minutes on the various test specimens: • 4140 Steel (reference material) • 15-5 PH Steel • Titanium 6A1-4V • Inconel 718 • Aluminum 7075 • Record time temperature data at the 0% , 25%, 50%, 75%, and 100% positions of the diameter. • Determine the loss of Ultimate Strength at the 5 minute and 15 minute intervals.

  6. Status • TESTING • Three out of the five material selected have been tested according to the prescribed procedure (4130 Steel, 15-5 PH Steel, and Titanium 6A1-4V) . • Available test data is currently been analyzed (reference material) • PROCEDURE • ARAC Subgroup is currently looking at the data to determine if a test protocol change is required.

More Related