1 / 1

Kinetic Energy Efficiencies of an Idealized Developing Tropical Cyclone

Kinetic Energy Efficiencies of an Idealized Developing Tropical Cyclone. Daniel P. Stern and David S. Nolan Rosenstiel School of Marine and Atmospheric Science University of Miami. Introduction

Download Presentation

Kinetic Energy Efficiencies of an Idealized Developing Tropical Cyclone

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Kinetic Energy Efficiencies of an Idealized Developing Tropical Cyclone Daniel P. Stern and David S. Nolan Rosenstiel School of Marine and Atmospheric Science University of Miami Introduction Forecast skill for tropical cyclone intensification remains relatively poor. Part of the problem results from gaps in our understanding of the basic internal dynamics of tropical cyclones. It is hoped that a better physical understanding of the effects that the structure of a cyclone has on its own intensification will eventually lead to improvements in intensity prediction. In this study, we use a linear model to investigate the intensification of an idealized, symmetric, hurricane-like vortex. A stable, balanced vortex is initialized from a mean tropical sounding and a vorticity profile chosen to provide a specified radius of maximum winds and maximum tangential velocity. A small temperature perturbation is then introduced into the vortex, and the vortex is allowed to evolve until it again reaches a balanced state. We define the Kinetic Energy Efficiency (KEE) to be the change in the kinetic energy of the symmetric wind field per unit heating associated with the initial perturbation. This process is repeated for perturbations introduced separately into each point in the (r,z) plane, thus showing how intensification varies with the location of heating. Many simulations were performed to determine the sensitivity of KEE to various parameters that characterize the vortex. These parameters include radius of maximum wind (RMW), maximum wind speed, latitude, and the type of vorticity profile. Simulations were performed with both Gaussian and modified Rankine vortex profiles. • Evolution of a Vortex Following an Instantaneous, Symmetric Heating Perturbation • Sensitivity of KEE to Vortex Structure • Summary The goal of this study was to investigate the influence that the internal structure of a hurricane-like vortex has on its own intensification. Specifically, we have quantified the amount of kinetic energy which is retained by a vortex following the introduction of a given heat perturbation, and to determine how this efficiency systematically varied with vortex structure. Significant conclusions are the following: • The final balanced response of a vortex following a symmetric heating perturbation centered at the RMW is a strengthening and broadening of the warm core. Since the maximum temperature change occurs between the center and the RMW, this is where the maximum pressure falls occur, tightening the gradient, and increasing the maximum windspeed. • Latent heat release would be theoretically most effective if it occurred at the center of the vortex and at and somewhat above the height of the warm core center. This is the region where inertial (static) stability is greatest (smallest). • Stronger vortices are much more efficient than weaker ones, in agreement with previous studies. For every 10 m/s increase in windspeed, efficiency increases by 0.7-1%. While that may seem small, it means that a 40 m/s vortex is about 7 or 8 times more efficient than a 10 m/s vortex. • Vortices at higher latitudes are significantly more efficient due to their increased inertial stability. • The effect of RMW appears to depend on the radial profile of vorticity outside the RMW, with a positive trend with increasing RMW for Gaussian vortices, little to no effect for a pure Rankine vortex, and a strongly negative trend for modified Rankine vortices with broad wind fields. • The efficiencies of modified Rankine vortices are very sensitive to the value of ‘a’, which determines the rate of radial decay of tangential wind beyond the RMW. Vortices with very slowly decaying winds (a = 0.1) can be 3 times more efficient than a pure Rankine vortex. This implies that the intensification rates of real tropical cyclones may be highly dependent on the structure of the wind field outside of the core. • In order to quantify the variation of efficiency with structure, it is necessary to come up with a single parameter that is representative of the efficiency of a real tropical cyclone subject to heating in and around the eyewall. • Mean KEE is defined as the KEE averaged over the volume between .5*RMW and 1.5*RMW, from 2-12km above the surface. • Shown to the right are plots of Mean KEE as a function of VMAX, latitude, and RMW. • VMAX is by far the most important parameter, with an approximate 8-fold increase of KEE as wind speed is increased from 10 to 40m/s. The relationship is approximately linear. • KEE increases with increasing latitude (Coriolis parameter). The absolute increase is larger for a stronger vortex. However, KEE increases by a greater percentage for the weaker vortex. The effect is approximately linear with the sine of the latitude. • KEE generally increases with increasing RMW, but appears to level off at large RMW. This particular model run was done at higher resolution and with a larger domain in an attempt to improve inconsistencies and “noise” at large RMW. Still, this plot isn’t as smooth as others, likely a result of the moving averaging domain, as well as the relatively small changes of KEE with RMW. • KEE is also somewhat dependent on the vertical structure of the vortex (not shown), as controlled by Lz and a. • The response of the vortex shown in (3) to a 1 K temperature perturbation introduced at t = 0 and centered at the RMW at a height of 5 km is shown below for t = 3 min, 30 min, and 300 min. Model Our methods are similar to those of Schubert and Hack (1982), Shapiro and Willoughby (1982), and Hack and Schubert (1986), but extended to allow for time-evolving, nonhydrostatic dynamics of perturbations to balanced vortices. We use the linear model developed by Nolan and Montgomery (2002) and Nolan and Grasso (2003), now known as Three Dimensional Vortex Perturbation Analysis and Simulation (3DVPAS). Here, we consider only symmetric perturbations generated by symmetric heating. An example of the domain and stretched grid used for most calculations. Reflection of radiating gravity waves is suppressed (and essentially eliminated) with Rayleigh damping regions along the upper and outer boundaries. • The initial response to the perturbation consists of upward motion at the radius of heating, and downward motion on either side. A secondary circulation is induced, and the tangential wind aloft begins increasing at the RMW. • At t = 30 min, the adjustment towards balance is unsteady, and gravity waves begin propagating outward. The maximum temperature perturbation is found near the tropopause. Tangential wind perturbations have now reached the surface. • At t = 5 hours, the vortex approaches a quasi-steady state. A packet of gravity waves continues traveling outward through the domain, decaying in amplitude. The maximum temperature perturbation is now inside of the RMW. The tangential wind increase is found in a narrow region around the RMW, with a maximum at about 4 km. • At t = 24 hours (not shown), the vortex is qualitatively similar to that at 5 hours. The gravity waves have decayed by several orders of magnitude and a new state of balance has been reached, with an increase in tangential wind speed and a warming and broadening of the warm core. Note that the final temperature change is a small fraction of the original 1 K perturbation. • Structure of Idealized Hurricane-like Vortices • Vortices with monotonically decreasing, Gaussian vorticity profiles are created from specified values of maximum wind speed (VMAX) and radius of maximum wind (RMW). • A vertical decay formula for the vorticity is used to extend the vortex in the vertical in a realistic manner. Two parameters are involved: Lz, which controls the depth of the region where velocity is nearly constant with height, and a, which controls the rate of decay in the baroclinic region. • The background field is a mean tropical sounding. • Once v(r,z) is specified, P(r,z) and T(r,z) are found through an iterative scheme as described in Nolan et al. (2001). Shown below are plots of a typical vortex used. VMAX = 25m/s and RMW = 40km. Lz = 6000 and a = 2.5. For most simulations that follow, f = 5.0x10-5 s-1. • 7. Efficiencies of Modified Rankine Vortices • A better approximation to the vorticity and wind distribution of real tropical cyclones is the modified Rankine vortex (Mallen et al. 2005). Rankine vortices are characterized by solid body rotation (constant vorticity) within the RMW and constant angular momentum (zero vorticity) outside the RMW. A modified Rankine vortex has winds which decay proportional to 1/ra beyond the RMW, where ‘a’ is a constant between 0 and 1. a = 1 for a pure Rankine vortex. For these calculations, we force the vortex to have a finite size. Shown to the right are plots of the variation of mean KEE with varying VMAX (for a = 0.3), RMW, and ‘a’. Below are radial profiles of velocity and vorticity for vortices with different ‘a’. • Efficiency decreases with increasing values of ‘a’. For VMAX = 15m/s, KEE is more than twice as large for a = .1 as it is for a pure Rankine vortex. At 30m/s, the difference is even greater, about a factor of 3. Since RMW, VMAX, and the vorticity profile inside the RMW are all held constant, this demonstrates a profound sensitivity of KEE to the vorticity profile in the outer core and beyond. • KEE increases with increasing VMAX, similar to the Gaussian vortices. • Unlike the Gaussian vortices, KEE generally decreases with increasing RMW, at a rate dependent on the value of ‘a’. It is more sensitive for small ‘a’. The efficiency of a pure Rankine vortex has very little (if any) dependence on RMW. Acknowledgments D. Stern has been supported through a University of Miami Graduate Fellowship, and this research is supported by NSF grant ATM-0432551. 10. References Hack, J. J. and W. H. Schubert, 1986: Nonlinear response of atmospheric vortices to heating by organized cumulus convection. J. Atmos. Sci.,43, 1559-1573. Mallen, K.J., M. T. Montgomery, and B. Wang, 2005: Reexamining the near-core radial structure of the tropical cyclone primary circulation: Implications for vortex resiliency. J. Atmos. Sci.,62, 408-425. Nolan, D.S., M. T. Montgomery, and L. D. Grasso, 2001: The wavenumber-one instability and trochoidal motion of hurricane-like vortices. J. Atmos. Sci.,58, 3243-3270. Nolan, D. S. and M. T. Montgomery, 2002: Nonhydrostatic, three-dimensional perturbations to balanced, hurricane-like vortices. Part I: Linearized formulation, stability, and evolution. J. Atmos. Sci., 59, 2989-3020. Nolan, D. S. and L. D. Grasso, 2003: Nonhydrostatic, three-dimensional perturbations to balanced, hurricane-like vortices. Part II: Symmetric response and nonlinear simulations. J. Atmos. Sci., 60, 2717-2745. Schubert, W. H. and J. J. Hack, 1982: Inertial stability and tropical cyclone development. J. Atmos. Sci.,39, 1687-1697. Shapiro, L.J. and H. E. Willoughby, 1982: The response of balanced hurricanes to local sources of heat and momentum. J. Atmos. Sci.,39, 378-394. • Kinetic Energy Efficiency There a number of physically meaningful measures of the efficiency of intensification, including surface pressure fall and the increase in V at the RMW. Unfortunately, the spatial distribution of these parameters with regards to the location of the heat bubble are not physically realistic. For example, the surface pressure fall is always maximized by heating at the center and near the surface, where significant latent heat release is unlikely to be found. Therefore, we define Kinetic Energy Efficiency (KEE) to be the change in kinetic energy of the vortex per unit heating. Shown below are some typical plots of the distribution of KEE. Note the relatively small magnitude of KEE; very little of the heat added is converted to the kinetic energy of the vortex, even under the most favorable circumstances. KEE is maximized at the center, but is also smoothly distributed over regions where significant heating would be expected to occur. Efficiency is generally a maximum at and just above the center of the warm core. 11. Corresponding Author Daniel Stern RSMAS/MPO 4600 Rickenbacker Causeway Miami, FL 33149 Email: dstern@rsmas.miami.edu

More Related