1 / 12

Modeling the Sliding of a Hard Wedge on a Metal Substrate

Modeling the Sliding of a Hard Wedge on a Metal Substrate. Ernesto Gutierrez- Miravete Rensselaer at Hartford CCAT- Summer 2010. Problem Description.

rashad
Download Presentation

Modeling the Sliding of a Hard Wedge on a Metal Substrate

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Modeling the Sliding of a Hard Wedge on a Metal Substrate Ernesto Gutierrez-Miravete Rensselaer at Hartford CCAT- Summer 2010

  2. Problem Description • A hard, rigid carbide wedge (semi-angle = a) moving at constant speed V encounters a metal block (breadth =b, hardness = H) and begins to slide over its surface to a certain depth = d, under plane strain conditions for a total sliding length = L. • Initially, a prow forms in front of the sliding wedge and is pushed by it (plowing). • The prow grows in size and eventually may transform into a chip that is in turn ejected in front of the wedge (cutting).

  3. Plowing vs Cutting

  4. Friction Coefficient due to Plastic Deformation during Plowing • Tangential Force: Ft = H d b • Normal Force: Fn = H d b tan a • Friction Coefficient: m = Ft/Fn = cot a • For the case herein considered a = 45 degrees so m = 1

  5. Finite Element Model • AdvantEdge (Third Wave Systems Inc.) is a commercial implementation of the finite element method designed to analyze the behavior of metals encountered during machining operations • The code embodies an explicit scheme capable of modeling coupled, non-linear thermo-mechanics at large strains and strain rates incorporating constitutive deformation behavior, contact, friction, fracture and adaptive meshing.

  6. Systems Investigated • The following alloy systems were investigated. The material property databases included in the software were used. The value of the friction coefficient in the code was set to 0. Al-6061-T6 1020 Steel Cu-37700 Brass Ti6Al4V • Other parameter values were as follows: d = 0.005 mm; V = 10 m/s; L = 0.1 mm

  7. Results- Al6061

  8. Results –1020 Steel

  9. Results – Cu 37700

  10. Results – Ti6Al4V

  11. Summary • In all cases considered, the computed normal forces were larger than the tangential forces. • Friction coefficient values calculated from the computed forces where in all cases within 10-20% of the expected value of 1. • Both, tangential and normal forces obtained under cutting conditions decreased to about ~80% of their values exhibited during plowing conditions. • The point of transition from plowing to cutting is material dependent.

  12. Modeling the Sliding of a Hard WedgeErnesto Gutierrez-MiraveteRensselaer-Hartford

More Related