1 / 24

2018-2019 Matlab Projects

ieee matlab projects<br>ieee matlab projects for eee<br>ieee matlab projects on image processing

neelablore
Download Presentation

2018-2019 Matlab Projects

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. http://www.projectsatbangalore.com A DIGITAL INSTRUMENT FOR VENOUS MUSCLE PUMP TEST

  2. Objective • To design and develop a prototype digital instrument to measure venous refilling time (VRT) and muscle pump capacity (MPC) for a Varicose Veins patient. http://www.projectsatbangalore.com

  3. Abstract • Design and development of a prototype unit to measure venous refilling time (VRT) and muscle pump capacity (MPC) during a venous muscle pump test (VMPT) is presented here. • Instead of normalizing the photo-plethysmo-graph (PPG), as is common in the VMPT instruments in vogue, a suitable signal processing technique that extracts a signal proportional only to the blood volume changes underneath the PPG sensor is employed.

  4. Block Diagram P I C M I C R O C O N T R O L L E R OP-AMP MAX232 PPG SENSOR POWER SUPPLY RS232 PC 16 X 2 LCD DISPLAY

  5. Block Diagram - Description • The hardware consists of a IRL81A sensor connected to the op-amp and a microcontroller unit for data acquisition, processing and display. • The analog signal is fed to one of the inputs of the 8-channel 10-bit A/D converter of the microcontroller. The built-in ADC of the PIC microcontroller converts analog to digital signal for processing. • The calibrated values are sent to the PC via RS232 port. • Thus Venous refilling time (VRT) and Muscle Pump Capacity (MPC) provides valuable information on the health of the veins, especially of the lower limbs of a patient.

  6. Hardware Used • PIC 16F877A • 16X2 LCD • IRL81A Sensor • MAX 232 IC • OP-AMP - LM358 • Power Supply • Transformer • Bridge Rectifier • Capacitor • 7805 Regulator

  7. Software Used • Matlab • Embedded C

  8. PIC16F877A • PIC16F877A 8-bit Micro controller is a small piece of semiconductor integrated circuit from Microchip Company. • Features: • 8 channels of 10-bit Analog-to-Digital (A/D) converter • Operating speed: 20 MHz • Data Memory: 368 bytes • EEPROM: 256 bytes • Flash Memory: 8KB • In-Circuit Serial Programming

  9. PIC16F877A - PIN DIAGRAM

  10. LCD • A liquid crystal display (LCD) is a flat panel display, electronic visual display, or video display that uses the light modulating properties of liquid crystals (LCs). LCs do not emit light directly. • LCDs are more energy efficient and offer safer disposal than CRTs • Its low electrical power consumption enables it to be used in battery-powered electronic equipment

  11. LCD 16X2 - PIN DIAGRAM

  12. IRL 81A Sensor

  13. MAX 232 • The MAX232 IC is used to convert the TTL/CMOS logic levels to RS232 logic levels during serial communication of microcontrollers with PC. • The controller operates at TTL logic level (0-5V) whereas the serial communication in PC works on RS232 standards (-25 V to + 25V).

  14. MAX232 - PIN DIAGRAM

  15. OP-AMP –LM358 • The LM358 is a dual operational amplifier IC that we use to build the op amp circuit. • It consists of two independent, high gain, internally frequency compensated operational amplifiers which were designed specifically to operate from a single power supply over a wide range of voltages. • Wide Power Supply Range: • Single Supply: 3V to 32V. • Dual Supplies: ±1.5V to ±16V.

  16. LM358 – PIN Diagram

  17. TRANSFORMER • A Transformer is a static electrical device that transfers energy by inductive coupling between its winding circuits. • Voltage: 12 • Current Rating: 500 Milliamps

  18. BRIDGE RECTIFIER • A diode bridge is an arrangement of four (or more) diodes in a bridge circuit configuration that provides the same polarity of output for either polarity of input. • The conversion of an AC input into a DC output, it is known as a bridge rectifier.

  19. Capacitor • Filter capacitors are capacitors used for filtering of undesirable frequencies. • Capacitance : 470µf

  20. REGULATOR - 7805 • LM7805 three terminal positive regulator IC • It provides fixed output voltage of 5 Volt • LM7805 Features: * Output Current up to 1A * Output Voltages of 5 volt * Thermal Overload Protection * Short Circuit Protection * Output Transistor Safe Operating Area protection

  21. Software Used • Matlab is used to plot the MPC and VRT variations coming from the device. • Embedded C is used for programming. The Programmed hex code is then burnt into the PIC Microcontroller using PICKIT Software.

  22. Circuit Diagram

  23. Conclusion • Venous refilling time (VRT) and Muscle Pump Capacity (MPC) provides valuable information on the health of the veins, especially of the lower limbs of a patient. • The design and development of a prototype unit to measure VRT and MPC during a standard venous muscle pump test (VMPT) utilizing the method of Photoplethysmography (PPG) has been presented. • The method employs a op-amp circuit to obtain a signal proportional only to blood volume changes underneath the PPG sensor

  24. THANK YOU

More Related