1 / 19

ECE 1201

ECE 1201. Engineering Lab II. Taaruf. Nor Farahidah Za’bah Room number : E2-2-13.12 Phone number : 03-61964562 Email address : adah510@iium.edu.my The lab technicians are Br. Mohd . Norazizi Hamzah and Br. Rosley Mahadi Course website: http :// staff.iium.edu.my/adah510.

morwen
Download Presentation

ECE 1201

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript

  1. ECE 1201 Engineering Lab II

  2. Taaruf • Nor FarahidahZa’bah • Room number : E2-2-13.12 • Phone number : 03-61964562 • Email address : adah510@iium.edu.my • The lab technicians are • Br. Mohd. NoraziziHamzah and Br. RosleyMahadi • Course website: • http://staff.iium.edu.my/adah510

  3. Assessment

  4. Safety • Please wear covered shoes – NO SLIPPER. Otherwise, you will be asked to leave the lab. • Power must be switched off whenever an experiment or project is being assembled, disassembled, or modified.

  5. Tidiness • When the experiment has been satisfactory completed and the results approved by the instructor, the students may disconnect the circuit and return the components and instruments to the locker tidily. • Chairs are to be slid in properly. • DO NOT WRITE anything on the table

  6. Pre-Lab Questions and Preparation • Please complete the pre-lab questions before each lab sessions. • It serves as guidance for you while doing your experiment • The answers are in your electronics textbook. • Read the entire experiment and research any required theory beforehand. Many times an experiment takes longer that one class period simply because a student is not well prepared. • The experiment is performed in pairs (max=3 students per group) but the final exam is performed individually • One group = one lab report

  7. Lab Reports • Reports have to be handwritten for submission. • Writing should appear on one side of each sheet only. • The students’ name & matric number, section number, lab session and the lecturer’s • Please indicate the author of each section in your report. • The cover page of the lab report can be downloaded from the website.

  8. Report Format and Evaluation

  9. Preparation for PSPICE Tutorial

  10. Preparation for PSPICE Tutorial • Download 16.6_OrCAD_Lite_Capture&PSpice_Products.zip from the any computer in the lab • It is a zipped file, you have to extract the files into a designated folder • Once you have extracted, go to Disk 1 and look for SETUP (it is an application file) to install the software. • One group will require ONE laptop for the tutorial sessions

  11. Introduction to Lab Equipment • Bread board and its connections

  12. Function Generator • To create AC signals such as Sine-Wave, Triangular Waves etc • The user can alter its frequency and amplitude Example of a function generator

  13. Oscilloscope • An equipment to show the obtained result. • Has 2 channels • One for input signal • One for output signal

  14. DC power supply • To provide DC supply to your circuit which you can measure using digital multimeter

More Related