1 / 20

TSM 363 Fluid Power Systems

TSM 363 Fluid Power Systems. Electronic Controls in Hydraulics Systems. Automated Functions – A Technical Trend. E/H Systems (Conventional Design). M. Controller. M. E/H Systems (Programmable Design). M. Controller. M. Basic Electrical Devices.

makya
Download Presentation

TSM 363 Fluid Power Systems

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. TSM 363 Fluid Power Systems Electronic Controls in Hydraulics Systems

  2. Automated Functions – A Technical Trend

  3. E/H Systems (Conventional Design) M Controller M

  4. E/H Systems (Programmable Design) M Controller M

  5. Basic Electrical Devices Seven devices commonly used in the control of electrohydraulic systems: • Push-button switches • Limit switches • Pressure switches • Drivers (Servo or Solenoids) • Relays • Timers • Temperature switches

  6. Operator control Input Signal time Valve control E/H Control Valves • On/Off solenoid • Proportional Solenoid • Low cost • PWM control of the solenoid • Advanced controls • Servo Valves • Torque motors • Costly, limited applications

  7. Option 1: Solenoid E/H Valve

  8. 1. Traditional air-gap type proportional solenoid driver 2. Wet-armature type proportional solenoid driver Commonly Used Proportional Solenoid Drivers

  9. Pulse-Width Modulation (PWM) Signal

  10. Va Vs Solenoid Characteristics of PWM Signals • Amplifier acts as a variable resistance to power solenoid • Voltage fully-on • Amplifier has zero resistance, no heat build-up • Maximum voltage to solenoid • Voltage fully-off • No power to amplifier, no heat buildup • High pulse-rate signal of full-on/full-off • Pulse rate is faster than the solenoid can react • Solenoid sees these as an average voltage

  11. Option 2: Two Stage E/H Valve

  12. Option 3: Servo E/H Valve • Servo mechanism • Electric motor • Position feedback potentiometer • Reduction gear • Actuator arm

  13. Output Input E/H Valve Actuator Open Loop Control Circuits • Simple circuit with no measurement of the performance at various settings

  14. Closed-Loop Control • Feedback enhances performance • Dynamic response and stability reference command + System dynamics output Controller - feedback

  15. Example of E/H Controls

  16. Properties of Valve Response: Deadband

  17. Properties of Valve Response: Saturation

  18. Properties of Valve Response: Hysteresis

  19. Properties of Valve Response: Stability Response Time

  20. Lecture Summary • Discussed the basic principles of electro-mechanical drivers for E/H valves: • Solenoid driver • Servo driver • Introduced a few key parameters describing the performance of an E/H valve: • Deadband • Saturation • Hysteresis

More Related