1 / 14

MPPT DC/DC Converter Design for Photovoltaic Powered Electric Vehicle Charging System

MPPT DC/DC Converter Design for Photovoltaic Powered Electric Vehicle Charging System. Fearghal Kineavy 4 th Energy Systems Engineering – Electrical Stream Department of Electrical and Electronic Engineering, NUIG Supervisor: Dr Maeve Duffy Co-Supervisor: Dr Edward Jones. Aim of the Project.

Download Presentation

MPPT DC/DC Converter Design for Photovoltaic Powered Electric Vehicle Charging System

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. MPPT DC/DC Converter Design for Photovoltaic Powered Electric Vehicle Charging System Fearghal Kineavy 4th Energy Systems Engineering – Electrical Stream Department of Electrical and Electronic Engineering, NUIG Supervisor: Dr Maeve Duffy Co-Supervisor: Dr Edward Jones

  2. Aim of the Project MPPT DC/DC Converter DC Charging Unit OR Onboard AC/DC Rectifier and charger DC/AC Inverter to grid

  3. Nissan Leaf

  4. Nissan Leaf • Best selling electric car in Ireland in 2011 • 80kW AC Motor • Max speed of more than 140km/h • Max range approx. 175km • 24kWh Li-ion battery • 48 modules connected in series

  5. Nissan Leaf Charging • Home charge point (AC) • Single phase 16A (3.6kW) supply • 6-8 hours to charge • Public charge point (AC) • 3 phase supply • 2-3 hours to charge • Fast charge points (DC) • 400V DC, 120A (50kW) supply • 20-25 minutes charges EV to approx. 80% charge

  6. Nissan Leaf Charge Connections CHAdeMO Connector (DC current) Mennekes Type 2 Connector (AC current)

  7. PV Panels Required to charge Leaf

  8. PV Panels Required to charge Leaf

  9. Demonstration System

  10. Progress so far… • Extensive research done into: • Nissan leaf battery and other li-ion batteries • PV panels • DC/DC converters • Maximum Power Point Tracking (MPPT) • Begun designing small scale charging system to prove concept • PV panel, li-ion cell and charger chosen • Buck converter will be used, inductor and capacitor values to be chosen • MPPT will be implemented using PWM from an arduino to control the duty cycle (Perturb and Observe MPPT)

  11. Still to do • Test Spectra 10W PV panel to determine I-V and P-V curves • Choose suitable current sensor • Test charge li-ion cell with DC source to determine charging profile • Create SPICE simulation circuit to help choose appropriate values for the buck converter components

  12. Still to do • Design and do detailed simulation of full size system using SPICE • Scale up demonstration SPICE model • Will most likely have to change model to a boost converter for full size system • Alter component values accordingly • Analyse the system at various operating conditions (full load, half load etc.) • Compare full size DC charging system with alternative DC-AC-DC system (better efficiency?) • Compile results and write final report

  13. Questions?

More Related