1 / 14

Forging new generations of engineers

A digital multimeter is a highly accurate tool that provides LCD number readouts, allowing for easy measurement of AC/DC voltage, resistance, and current. Learn how to use the various functions and test leads for voltage, resistance, and current measurements.

knagy
Download Presentation

Forging new generations of engineers

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Forging new generations of engineers

  2. Digital Multimeter

  3. A digital multimeter is highly accurate and provides LCD number readouts. It can easily measure AC / DC voltage, resistance, and current. What is a Digital Multimeter?

  4. Test Leads Test leads are used to connect the multimeter to the circuit to be tested.

  5. DC Voltage AC Voltage Battery Test Resistance DC Current Continuity Test Function/Range Switch

  6. The volt meter is used to measure the voltage potential across a component in an active circuit. Can be used to measure either DC or AC voltages. AC voltage can ONLY measure sinusoidal (SINE) waveforms. Voltage Meter

  7. Plug the RED test leadinto the jack labeled V/ and the BLACK test lead into the jack labeled COM (common). Test Lead Connections - Voltage

  8. Ohm Meter The ohm meter is used to measure the resistance of a component. NO POWER can applied to the component being tested. The ohm meter actually applies a small voltage and uses ohms law to calculate the resistance from the measured current.

  9. Same As Voltage Measurement Test Lead Connections - Resistance

  10. Ampere Meter The amp meter is used to measure the current through a component in an active circuit. Can be used to measure only DC current. Some multimeters can also measure AC current

  11. Plug the RED test lead into the jack labeled mA for milliamps or into the jack labeled 10A for circuits with high current levels. Plug the BLACK test lead into the jack labeled COM. Be certain to select the range according to the test lead connections. Observe proper polarity. Test Lead Connections - Current

  12. Basic Instructions • Be sure the test leads are connected properly for measurement being made. • Turn the meter’s Function/Range switch to the function (ACV, DCV, DCA or ) setting you are measuring. • Select at a range which is higher than the expected value. • Connect the test leads to the circuit/component begin tested. Observe proper polarity. • Turn the meter’s Function/Range switch to reduce the range and increase the accuracy. • Record results. • Remember to turn the power OFF.

  13. Special Functions • Continuity Tester • Used to test the continuity between two points. Will produce an audio tone. • Diode Tester • Used to test the resistance in a diode for forward bias and reverse bias. • Battery Tester • Used to test 9 volt and 1.5 volts (AAA,AA, C, D) batteries.

  14. If the Meter Malfunctions : • Check battery. • Review instructions to make sure you are doing it properly. • See if test leads are broken or not connected properly. • Inspect and test the fuse.

More Related