1 / 13

Woodwork Lathe

Woodwork Lathe. Revolving Centre. Forked Centre. Headstock. Tailstock. Bed. ToolPost. Toolrest. On/Off Switch. Lathe Parts. When turning between centres the work piece is held between a Forked Centre and a Revolving Centre. Headstock.

hyunshik
Download Presentation

Woodwork Lathe

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Woodwork Lathe

  2. Revolving Centre Forked Centre Headstock Tailstock Bed ToolPost Toolrest On/Off Switch Lathe Parts

  3. When turning between centres the work piece is held between a Forked Centre and a Revolving Centre

  4. Headstock The headstock supports one end of the work piece. It contains the driveshaft as shown below.

  5. Forked Centre The Headstock can be fitted with a Forked Centre to support one end of the work piece when turning between centres.

  6. Tailstock Locking Lever Tailstock The tailstock supports the other end of the work piece

  7. To support this end a Revolving Centre or Dead Centre must be fitted in the tailstock. Revolving Centre Dead Centre

  8. The Parting tool The parting tool can be used to cut narrow slots in your work piece.

  9. The Gouge Cross Section The Gouge utilises a slicing action and can be used for both roughing down and fine finishing

  10. The Skew Chisel The skew chisel can be used to produce a very smooth finish When using this tool remember only to use the bottom third of the blade Copper

  11. The Scraper Scrapers are available in a wide range of shapes and sizes. Scrapers are among the easiest lathe tools to use however as the name suggests the tool scrapes rather than cuts and can leave a rather rough finish.

  12. The Faceplate A Faceplate is used to attach a wood blank to the lathe when making a bowl Faceplate

  13. The End

More Related