1 / 9

The Roller Coaster Project

“The Pocket Rocket”. The Roller Coaster Project. picture. Group Members: Jonny Weigand , David Upchurch, and Jacob White. Brainstorming…. Actual Design. 2 pieces Initial drop (.5 sec) Spiral (8 sec) Connection to other tubing (1 sec) Drop (.2 sec) Loop (.3 sec)

hovan
Download Presentation

The Roller Coaster Project

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. “The Pocket Rocket” The Roller Coaster Project picture Group Members: Jonny Weigand, David Upchurch, and Jacob White

  2. Brainstorming…

  3. Actual Design • 2 pieces • Initial drop (.5 sec) • Spiral (8 sec) • Connection to other tubing (1 sec) • Drop (.2 sec) • Loop (.3 sec) • Downhill roll to end (5 sec)

  4. Energy • Mass of ball = 0.0011 kg • COE for 1st drop • mgh = ½ mv2 + mgh • COE for start of spiral • ½ mv2 + mgh= ½ mv2 • Ball stops at connection • COE for drop, loop, and decline • mgh = ½ mv2 • Energy loss from friction • mgh = Eloss

  5. Issues • Fitting length of tubing in constraint • Mounting supports vertically straight • Plastic tubing too stiff • Reinforced tubing too rough • Making loop with limited PE • Tubing shifting

  6. Conclusions • Calculated speed too high • Friction of reinforced tubing • More flexible tubing • Simpler preliminary designs

  7. The End

  8. Construction • Procedure • Drilled 5 holes in base board for pvc supports • Cut pvc supports to length • Assembled supports on base board • Measured each guide pipe height • Zip tied the guide pipes at respective heights onto the supports • Weaved the plastic tubing through while testing periodically • Tested and connected bottom tubing

  9. Construction • Materials • 1 steel ball bearing ($0.40) • 20’ of ½” pvc pipe ($8.50) • 4 ½” pvc couplings ($1.00) • 25’ plastic tubing ($5.00) • 13’ rubber reinforced tubing ($9.10) • 10 nails ($0.50) • Super glue ($1.00) • ½ m by ½ m by ½ in piece of particle board ($3.00) • 1’ of 2 x 4 ($1.00) • 50 zip ties ($3.00) • Ductape ($2.00) Total cost = $34.50

More Related