1 / 10

Lab 6 – Data Acquisition Systems

Lab 6 – Data Acquisition Systems. Start date: Week #9 Due date: Week #10. Overview of the A/D system. On-board A/D is 8-channel, 8-bit successive approximation Modes 8 conversions or 4 conversions Continuous or single scan 1 channel vs. multiple channels (4 or 8). Registers. ATDCTL2

Download Presentation

Lab 6 – Data Acquisition Systems

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Lab 6 – Data Acquisition Systems Start date: Week #9 Due date: Week #10

  2. Overview of the A/D system • On-board A/D is 8-channel, 8-bit successive approximation • Modes • 8 conversions or 4 conversions • Continuous or single scan • 1 channel vs. multiple channels (4 or 8)

  3. Registers • ATDCTL2 • Power-up • Interrupt enable • ATDCTL5 • Mode – 8 or 4 channel, continuous or single scan, single or multiple channel • See table (p.95) to properly select channels

  4. Registers • ATDSTAT • Flags • ADRxH • Result registers • (ATDCTL4) • If you want to set timings

  5. Hints • Don’t forget to hook up the reference voltages for the A/D • Don’t mix up the +5/ground with the +/- 15V lines • Do not use the scope’s infinite mode

  6. Academic Misconduct • Reports and demos are submitted as a group, but it is a SINGLE group effort • You may talk with other groups but sharing code or reports is NOT ALLOWED • Copying code/reports from previous years is also NOT ALLOWED • If we find copying we are REQUIRED to report it

  7. End of Slides

  8. D/A • D/A chip – DAC0800 • Requires reference voltages and power for the chip • +/- 15 is a good power for the chip because you have it on your power supplies • DON’T MIX UP THE LINES PLEASE • Output of the chip is CURRENT!! • You need to change this to voltage somehow to get it to work with the scope

  9. D/A • In report • Include calculations • Describe the setup and why it was set up like that • Include a diagram

  10. Scope • Use the X-Y mode on the scope to draw • If you don’t know how to use the scope, ask • You MAY NOT use the infinite mode on the scope – you must use a software buffer in your own code

More Related