1 / 19

Rectifier and Bond Reading

Learn how to calculate current using shunt formulas, convert voltage units, and measure amp drain in basic electric circuits. Understand the application of resistors and the importance of disconnecting bond wires. Discover alternative methods for measuring amp drain using shunts.

gsabella
Download Presentation

Rectifier and Bond Reading

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Rectifier and Bond Reading Tim Jenkins

  2. Basic Electric - Shunts

  3. Basic Electric - Shunt Formulas • Calculate Current • Given - Shunt ( .01 ohms & voltage across the shunt = 50 Mv) • Convert units of voltage, 50mv = .05v • Calculate current using Ohm’s law • I = .05 v/.01 ohms = 5 amps • Given - Shunt ( 15 amps, 50mV) • Measured voltage drop = 28mV • Determine shunt rating • Rating = 15 amps/50mV = .3 amps / mV • Calculate current • Current = .3 amps / mV x 28 mV = 8.4 amps

  4. Slide Resister Application

  5. Resister Wire Application The amount of Resistance is made by the Length of the Wire.

  6. Disconnect Bond Wire for Amp Drain Reading

  7. 1.36 Amp Current Drain Make Connection in series with the Circuit Amp Drain Reading

  8. Slide Resister Lighting Arrestor

  9. Connection Made on Resister from Foreign Structure and Columbia.

  10. Disconnection to get Amp Drain must be made in series with the circuit.

  11. Direct Bond Connection, No Resistance

  12. Shunt Resister

  13. Measuring Amp Drain by Measuring Voltage Drop Across the Shunt. Ratio is normally found on Shunt. .001V = 1A

  14. 7 milivolts = 7 Amps Make connection across Shunt. Polarity does not matter.

  15. Ratio for Shunt Shunts do not have to be disconnected in BI-monthly and Annual inspection.

  16. Alternative method – use shunt for amp readings. Take mili-volt reading across shunt then use ratio to figure total amps. Connect meter in serious for amp reading on the structure or anode wire.

More Related