1 / 19

Electric Circuits Review

Electric Circuits Review. Chapter 17 & 18. Electrical resistance in a wire depends on the wire’s. Resistivity Length Cross sectional area All of the above.

Download Presentation

Electric Circuits Review

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Electric Circuits Review Chapter 17 & 18

  2. Electrical resistance in a wire depends on the wire’s • Resistivity • Length • Cross sectional area • All of the above

  3. A metallic conductor has a resistivity of 18 x 10-6Wm. What is the resistance of a piece that is 30 m long and has a uniform cross sectional area of 3.0 x 10-6 m2?

  4. A 0.20-m-long metal rod has a radius of 1.0 cm and a resistance of 3.2 x10-5W. What is the resistivity of the metal?

  5. When two light bulbs are connected in series • The same amount of current flows through each light bulb. • The current through each light bulb is proportional to the resistivity of the bulb. • The light bulbs will not work unless there is a fuse in the circuit. • There are at least two branches of the circuit.

  6. When one light bulb in a series circuit containing several light bulbs burns out… a. The other light bulbs burn more brightly b. Nothing changes in the rest of the circuit c. None of the other bulbs will light up

  7. When resistors are put in series, their overall resistance is a. Larger than that of any individual resistor b. The same as the resistance of one of the resistors c. Smaller than the resistance of any of the resistors

  8. When resistors are put in parallel, their overall resistance is a. Larger than that of any individual resistor b. The same as the resistance of one of the resistors c. Smaller than the resistance of any of the resistors

  9. A wire 5.0 m long and 3.0 mm in diameter has a resistance of 100 W. A 15 V potential difference is applied across the wire. What is the current in the wire?

  10. Two appliances operate at the same voltage. Appliance A has a higher power rating then appliance B. How does the resistance on A compare with that of B • A’s resistance is larger than B’s. • A’s resistance is smaller than B’s • A’s resistance is the same as B’s.

  11. What is the resistance of a 100. W light bulb if it is plugged into a 120. V outlet?

  12. Three resistors with resistance of 6 , 12 , and 24  are connected in series. What is the total resistance of the circuit?

  13. Three resistors with resistance of 6.0 , 12 , and 24  are connected in series with a 12V battery. What is the current through the 12  resistor? The current is the same through all of them so the total resistance must be used.

  14. 12  6  6  6  6  What is the total resistance of this partial circuit? 12 

  15. 6  6  What is the current through each of the resistors in the following circuit? (Rtotal = 4.5 ) 12 V 12 

  16. What is the current in the 10-W resistor?

  17. Which two resistors are in parallel with each other? R2 and R3

  18. FINAL JEOPARDY Teams, place your bets

  19. How much power is being dissipated by one of the 10  resistors? P = IV = V2/R = I2R

More Related