1 / 18

PDSOI and Radiation Effects: An Overview

PDSOI and Radiation Effects: An Overview. Josh Forgione NASA GSFC / George Washington University. Abstract. Silicon-On-Insulator (SOI) Complementary Metal-Oxide-Semiconductor (CMOS) An alternative to bulk CMOS for radiation environments SOI dielectric isolates device layer from substrate.

adonis
Download Presentation

PDSOI and Radiation Effects: An Overview

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. PDSOI and Radiation Effects: An Overview Josh Forgione NASA GSFC / George Washington University MAPLD 2005/P104

  2. Abstract • Silicon-On-Insulator (SOI) Complementary Metal-Oxide-Semiconductor (CMOS) • An alternative to bulk CMOS for radiation environments • SOI dielectric isolates device layer from substrate. • Long-time appeal to military and aerospace IC designers. • Discussion focus: • Investigate behavior of Partially-Depleted SOI (PDSOI) device with respect to three common space radiation effects: • Total Ionized Dose (TID) • Single-Event Upsets (SEUs) • Single-Event Latchup (SEL). • Test and simulation results from literature and bulk comparisons facilitate reinforcement of PDSOI radiation characteristics. MAPLD 2005/P104

  3. + VS VG + VD + VS VG + VD n+ n+ p+ p+ n well P-type, ‘Bulk’’ Substrate Introduction • Traditional CMOS is fabricated on a bulk substrate. Figure 1: Bulk CMOS device structure MAPLD 2005/P104

  4. + VS VG + VD + VS VG + VD SiO2 Insulator – ‘Buried Oxide’ n+ n+ n+ p p p p Substrate Introduction • SOI MOSFETs are isolate from the substrate and each other via a thick insulator, or ‘buried oxide’ (BOX) Figure 2: SOI CMOS device structure MAPLD 2005/P104

  5. Introduction • Device-layer thickness (tsi) determines one of two main SOI types • Partially-Depleted SOI (PDSOI): tsi > 2*xdmax • Focus of discussion • Fully-Depleted SOI (FDSOI): tsi < xdmax A: PDSOI B: FDSOI Front Gate Oxide Front Gate Oxide xdmax Front Gate Depletion Fully Depleted Body tSi xdmax tSi p Body Back Gate Buried Oxide (BOX) Back Gate Depletion Back Gate Buried Oxide (BOX) Figure 3: Distances between front and back-gate depletion regions define PDSOI (A) and FDSOI (B). MAPLD 2005/P104

  6. VG VG + VS + VD + VS + VD p n+ p n+ n+ n+ Buried Oxide (BOX) Buried Oxide (BOX) p substrate (back gate) p substrate (back gate) VBG VBG Introduction • Equivalent PDSOI circuit model: Figure 4: Transistors (left), capacitors, and diodes (right) embedded in the PDSOI MOSFET structure. MAPLD 2005/P104

  7. Introduction • PDSOI ‘floating body’ effects • Results from inherent, un-terminated body • Body-source junction can forward-bias parasitic Bipolar Junction Transistor (BJT) • Current transient • Body-source potential affects threshold voltage • Can be alleviated (but not cured!) using body ties • Body ties = Body potential connected to known reference • Difficult to implement for each transistor in a device • A must for space-flight designs MAPLD 2005/P104

  8. SOI and Single Event Latchup (SEL) • Incoming charged particles can activate parasitic thyristor structure in bulk CMOS devices • Can result in permanent device failure • SOI’s adjacent device isolation eliminates the possibility of SEL entirely. Figure 5: Cross section of a p-well CMOS inverter, with parasitic elements pertinent to latch-up[1] MAPLD 2005/P104

  9. PDSOI and SEUs • Significant SOI cross-sectional area decrease • Deposited charge in substrate cannot return to depletion region • Theoretical result: • Decreased current transients • SOI devices less susceptible to SEU Figure 6: Conceptual distribution of charge funnels in bulk (a) and SOI (a) devices. The SOI device dramatically reduces the area for collected charge[via 3]. MAPLD 2005/P104

  10. PDSOI and SEUs Figure 7: Sensitivity of the 68020 microprocessor, in CMOS/thick SOI and CMOS/epi taxial technologies, for two different test programs[4 via 5]. MAPLD 2005/P104

  11. PDSOI and SEUs Figure 8: Peak transient current as a function of strike Linear Energy Transfer (LET) and technology scaling for bulk and SOI technologies[6] MAPLD 2005/P104

  12. VG + VS + VD n+ p n+ Buried Oxide (BOX) p substrate (back gate) VBG SEU and SOI • Parasitic BJT increases SEU sensitivity • Amplifies deposited charge • Can completely null SOI SEU advantages due to reduced cross-sectional area[2] • Spaceflight designs require body ties • Decreases BJT gain (β) Figure 9: Parasitic BJT in PDSOI Table I: Experimental and Calculated LET Threshold in SOI SRAMs in MeV/(mg/cm2), Bipolar Amplification Factors β*[4] MAPLD 2005/P104

  13. PDSOI and TID • Gate-oxide charge traps can disable a bulk or SOI device • Increased leakage currents lead to threshold voltage shifts. • PDSOI buried-oxide charge traps can activate the back-gate transistor • May increased front-gate leakage currents and cause threshold voltage shifts. • Process and device design techniques can reduce the effects of trapped charge in the buried oxide[7]. MAPLD 2005/P104

  14. PDSOI and TID Figure 10: Drain-to-Source (DS) I-V characteristics for (a) a back-gate transistor irradiated to 1 Mrad (SiO2) and its effect on (b) the top-gate transistor leakage current. The transistors were irradiated in the OFF (VGS = VS = 0V; VDS = 5V) bias condition[8]. MAPLD 2005/P104

  15. Conclusions • SOI often used for low-power, high-speed devices • Desired features in military and aerospace designs • SOI SEL immunity does not infer a a cure-all for radiation-tolerant designs • Inherent parasitics lead to TID and SEU sensitivities in PDSOI. MAPLD 2005/P104

  16. Conclusions • Radiation effects omitted from discussion: • Proton secondary effects • Analog and Digital Single-Event Transients (ASETs, DSETs, respectively) • Dose rate • Etc., etc. • All effects and appropriate mitigation methods must be considered during design MAPLD 2005/P104

  17. References [1] R.S. Muller, T.I. Kamins, Device Electronics for Integrated Circuits. New York: John Wiley & Sons, Inc, 2003. [2] A. G. Holmes-Siedle, Len Adams, Handbook of radiation Effects. Oxford University Press, 2002. [3] J.P. Coligne, Silicon on Insulator Technology: Materials to VLSI. Boston: Kluwer, 2003. [4] P. Lestrat, et. al, “SOI 68T020 Heavy Ions Evaluation,” IEEE Transactions on Nuclear Science, vol. 41, p. 2240, 1994. [5] O. Musseau, “Single-Event Effects in SOI Technologies and Devices,” IEEE Transactions on Nuclear Science, vol. 43, p. 603. April 1996. [6] P. Dodd, et. al, “Production and Propagation of Single-Event Transients in High- Speed Digital Logic ICs,” IEEE Transactions on Nuclear Science, vol. 51, p. 3278, December 2004. [7] K. Bernstein, SOI Circuit Design Concepts. Hingham, MA: Kluwer, 2000. [8] J.R. Schwank, “Radiation Effects in SOI Technologies,” IEEE Transactions on Nuclear Science, vol. 50, p. 522. June 2003. MAPLD 2005/P104

  18. PDSOI and Radiation Effects: An Overview Josh Forgione NASA GSFC / George Washington University MAPLD 2005/P104

More Related