PROFILES CREATE STATION LABELS

1. LABEL CENTERLINES OF DAMS, WATERWAYS, DIVERSIONS ETC. To create a profile, you must first sample the existing ground from a surface. Sampling the existing ground creates elevational values for the profile. When sampling the existing ground data from surfaces, you have the option to sample one or multiple surfaces at the same time. To sample multiple surfaces, you must first create a file of the surface names that you want to sample using the Select Multiple Surfaces command. Then you must enable the use of multiple surfaces before sampling the data using the Toggle Multiple Surfaces command. PROFILESCREATE STATION LABELS

2. WHILE IN MODEL SPACE, WITH ITEM TO BE LABELED

3. SELECT POLYLINE

4. START POLYLINE WHERE YOU WOULD LIKE TO START THE SAMPLING

5. PULL POLYLINE ACROSS THE SURFACES TO BE DISPLAYED

6. FROM TERRAIN, SELECT DEFINE FROM POLYLINE

7. SELECT THE POLYLINE JUST CREATED

8. A RED X APPEARS AT THE STARTING POINT OF THE LINE. TO ACCEPT THIS POINT HIT ENTER

9. NAME THE ALIGNMENT AND SELECT A STARTING STATION REFERENCE, (IE, 0 OR 100). HIT OK

11. PROFILES SURFACES SET CURRENT SURFACE

12. SELECT THE EXISTING GROUND SURFACE HIT OK

13. PROFILES SURFACES TOGGLE MULTIPLE SURFACES

15. PROFILES SURFACES SELECT MULTIPLE SURFACES

16. HOLDING DOWN THE SHIFT BUTTON, SELECT THE SURFACES TO BE SAMPLED (IF THEY ARE NOT TO BE NEXT TO EACH OTHER, USE THE CONTROL KEY TO SELECT MORE THAN ONE.) HIT OK

17. PROFILES EXISTING GROUND SAMPLE FROM SURFACE

18. LEAVE UNCHECKED, SAMPLED DATA APPEARS ON BOTTOM, HIT OK

19. HIT ENTER

20. HIT ENTER

21. 336 FEET OF PROFILE WILL NEEDTO FIT ON PAPER

22. PROJECTS DRAWING SETUP

23. SELECT A SCALE THAT WILL FIT HORIZONTALLY ON THE PAPER SIZE HIT OK

24. PROFILES CREATE PROFILE FULL PROFILE

25. SELECT THE EXISTING GROUND SURFACE, SELECT OK

26. VERTICAL SCALE FACTOR FROM: PROJECTS DRAWING SETUP CAN BE OVERWRITTEN.

27. SELECT A POINT AWAY FROM SURVEY

28. SELECT NO (UNLESS YOU WANT TO DELETE ALL OTHER PROFILE LAYERS

29. PROFILE BROUGHT INTO DRAWING STILL IN MODEL SPACE

30. APPEARS TOO TALL FOR 1”=40’

31. TO REDO THE PROFILE, GO BACK TO: PROFILES CREATE PROFILE FULL PROFILE

32. CHANGE VERTICAL SCALE FACTOR TO ALTER THE APPEARANCE OF THE PROFILE, NEW VALUE OF 8 WAS ENTERED

33. NEW PROFILE IS NEATER

35. TO LABEL THE ALIGNMENT FROM ALIGNMENTS SELECT CURRENT ALIGNMENT

36. FROM ALIGNMENTS SELECT STATION LABEL SETTINGS

37. SET THE DISTANCE YOU WANT THE LABELS AND TICKS TO APPEAR, SELECT OK

38. FROM ALIGNMENTS SELECT CREATE STATION LABELS BEGINNING STATION DEFAULTS ON THE FIRST STATION, CHANGE OR HIT ENTER

39. ENTER TO ACCEPT THE STATIONS

40. ``` ``` IF YOU HAVE EXISTING LABELS THAT YOU DO NOT WANT TO LOSE , SELECT NO

42. TO LABEL SPECIFIC POINTS: FROM ALIGNMENTS SELECT STATION\OFFSET, LABEL

44. PULL LINE OUT

45. HIT ENTER

46. STATION AND OFFSET APPEAR

47. TEXT HAS BEEN EDITED