1 / 34

Planting & Maintenance of Ornamental Plants

Planting & Maintenance of Ornamental Plants. By: Johnny M. Jessup Agriculture Teacher/FFA Advisor. Introduction. Tools vary depending upon type and size of plants. Tools range from…. Bulb planter Trowel Spade. Shovel Power auger Front end loader. Planting Hole.

Download Presentation

Planting & Maintenance of Ornamental Plants

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Planting & Maintenance of Ornamental Plants By: Johnny M. Jessup Agriculture Teacher/FFA Advisor

  2. Introduction • Tools vary depending upon type and size of plants. • Tools range from…. • Bulb planter • Trowel • Spade • Shovel • Power auger • Front end loader

  3. Planting Hole • Hole should be larger than plant roots. • Soil should be prepared so that new roots will grow in it.

  4. BARE-ROOT Installation Method • Installation method is determined by the root form whether it is…. • Bare-rooted • Balled-and-burlapped • Containerized

  5. Bare-Rooted Plants • Have to have a mound or dome in the bottom of the hole to spread roots and direct them to grow downward.

  6. Balled & Burlapped Plants • Have a round soil ball of roots wrapped in burlap fabric. • Planted in a hole that is…. • Flat-bottomed. • Straight-sided. • Deeper & wider than ball.

  7. Balled & Burlapped Plants • Backfill soil should fill the hole enough to raise the plant to the level at which it grew in the nursery. • Loosen burlap around the top of the plant. • A mounded ring of soil should be formed around plant to catch water.

  8. Containerized Plants • Uses the same type of hole, mounded ring and etc. as balled and burlapped plants.

  9. Containerized Plants • The plant must be removed from the container and the roots unwound or cut at 2 inch intervals if pot-bound.

  10. Containerized Plants

  11. Staking • Tall plants, even small trees, need to be staked to prevent blowing over.

  12. Staking

  13. Mulching • Should be done to help…. • Retain water. • Prevent weeds. • Improve appearance. • Minimize temperature fluctuations.

  14. Watering • Water adequately and frequently enough for healthy plants.

  15. Handling • Balled & Burlapped • Should be handled by the root ball. • Container-Grown • Should be handled by the container until it is removed. • Then it is held by the roots.

  16. Maintenance & Care of Landscape

  17. Maintenance Program • Usually includes…. • Watering • Fertilizing • Mulching • Pruning • Pest Control • Mowing • Edging • Winterization

  18. Watering • Should be infrequent and enough to wet soil 12 – 16” deep. • Different plants have different water needs.

  19. Watering • Should be done at planting & frequently for a few days to prevent roots from drying out & plant wilting. • Then less often only as needed.

  20. Fertilization • Usually not needed for established trees, but…. • It should be done by making holes with a drill or soil tube about 12” deep and at 24” intervals around the tree at the canopy drip line where needed.

  21. Fertilization • Shrubs may need small amounts of low analysis fertilizer, but…. • Not late in the growing season. • Most lawns need fertilizer. • Fertilizer should be mixed in back fill soil at planting for shrubs & trees and in soil bed for annuals & perennials.

  22. Mulching • Should be done at planting and replaced as needed. • Must be replaced over time as it decays.

  23. Pruning • Done to improve appearance & health and to control size & shape of plants. • Early spring flowering plants should be pruned immediately after flowers fall off.

  24. Pruning • Usually done in off-seasons when more labor is available; however…. • Some plants have to be pruned at specific times.

  25. Pruning • Early Spring Blooming Shrubs • Should be pruned as soon as flowers fall off so that new buds can form for next year. • Damaged Branches • Should be removed as soon as possible to prevent more damage to plant

  26. Pruning • Plants w/ High Sap Pressure in Early Spring • Should not be pruned in spring. • Examples include birches & maples. • Newly Planted Trees & Shrubs • Should be shaped.

  27. Pest Control • To prevent damage, pests need to be controlled such as…. • Insects • Diseases • Weeds • Rodents

  28. Pest Control • Done by treating the beds and other areas with chemicals before planting and as observed to prevent…. • Weeds • Insects • Diseases

  29. Mowing • The keys to maintaining lawns are…. • Mow at the correct height for the type of grass. • Mow frequently enough to prevent damage.

  30. Edging • Makes a sharp line of separation between a planting and the a lawn. • Can be done with tools or with an edging material such as plastic. • Should be installed at planting time.

  31. Winterization • Prepares plants for the winter or freezing weather. • Fertilize early enough in the growing season to prevent soft new growth that will die in winter.

  32. Winterization • Practices that help plants survive freezing temperatures of winter include…. • Mulching. • Pruning. • Adequate watering. • Pest control.

  33. Maintenance Schedule • Careful observation of newly planted shrubs, trees, annuals, and perennials on a regular basis will determine the time and amount of maintenance needed.

  34. Designed By: • Johnny M. Jessup; FFA Advisor • Hobbton High School

More Related