1 / 49

HW # 6 /Tutorial # 6 WRF Chapter 20; WWWR Chapters 21 & 22 ID Chapters 10 & 11

Tutorial # 6 WRF#20.6; WWWR #21.13, 21.14; WRF#20.7; WWWR# 21.19. 22.3, 22.15. Hint: 21.13: You may neglect the temperature drop across the tube wall. Suggested initial guess: Tw = 58 o C, Ti(out) = 36 o C. To be discussed during the week 2 - 6 March, 2020.

trembley
Download Presentation

HW # 6 /Tutorial # 6 WRF Chapter 20; WWWR Chapters 21 & 22 ID Chapters 10 & 11

An Image/Link below is provided (as is) to download presentation Download Policy: Content on the Website is provided to you AS IS for your information and personal use and may not be sold / licensed / shared on other websites without getting consent from its author. Content is provided to you AS IS for your information and personal use only. Download presentation by click this link. While downloading, if for some reason you are not able to download a presentation, the publisher may have deleted the file from their server. During download, if you can't get a presentation, the file might be deleted by the publisher.

E N D

Presentation Transcript


  1. Tutorial # 6 WRF#20.6; WWWR #21.13, 21.14; WRF#20.7; WWWR# 21.19. 22.3, 22.15. Hint: 21.13: You may neglect the temperature drop across the tube wall. Suggested initial guess: Tw = 58oC, Ti(out) = 36oC. To be discussed during the week 2 - 6 March, 2020. By either volunteer or class list. Homework # 6 (Self-practice) WWWR # 21.17Correction:“If eight tubes of the size designated in Problem WRF 20.7.” ID # 10.54 HW # 6 /Tutorial # 6WRF Chapter 20; WWWR Chapters 21 & 22ID Chapters 10 & 11

  2. Boiling and Condensation

  3. Boiling Two basic types of boiling: • Pool boiling • Occurs on heated surface submerged in a liquid pool which is not agitated • Flow boiling • Occurs in flowing stream • Boiling surface may be a portion of flow passage • Flow of liquid and vapor important type of 2 phase flow

  4. Regimes of Boiling

  5. Regime 1: • Wire surface temperature is only a few degrees higher than the surrounding saturated liquid • Natural convection currents circulate the superheated liquid • Evaporation occurs at the free liquid surface as the superheated liquid reaches that position

  6. Regime 2: • Increase in wire temperature is accompanied by the formation of vapor bubbles on the wire surface • These bubbles form at certain surface sites, where vapor bubble nuclei are present, break off and condense before reaching the free liquid surface At a higher surface temperature, as in regime III, larger and more numerous bubbles form, break away from the wire surface, rise, and reach the free surface. Regimes II & III are associated with nucleate boiling.

  7. Regime IV: • Beyond the peak of the curve the transition boiling regime is entered. • A vapor film forms around the wire, and portions of this film break off and rise, briefly exposing a portion of the wire surface • This film collapse and reformation and this unstable nature of the film is characteristic of the transition regime. • When present, the vapor film provides a considerable resistance to heat transfer, thus the heat flux decreases.

  8. Correlations of Boiling Heat-Transfer Data

  9. surface tension Nub = Cfc Rebm PrLn Refer to Appendix 6 for Detailed Derivation.

  10. As confirmed by Cengel 2007

  11. Condensation • Occurs when a vapor contacts a surface which is at a temperature below the saturation temperature of the vapor. • When the liquid condensate forms on the surface, it will flow under the influence of gravity.

  12. Film Condensation • Normally the liquid wets the surface, spreads out and forms a film. • Dropwise Condensation • If the surface is not wetted by the liquid, then droplets form and run down the surface, coalescing as they contact other condensate droplets.

  13. Example 1

  14. 4A rLu Re = P mf Film Condensation: Turbulent-Flow Analysis • It is logical to expect the flow of the condensate film to become turbulent for relatively long surfaces or for high condensation rates. • The criterion for turbulent flow is a Reynolds number for the condensate film. • In terms of an equivalent diameter, the applicable Reynolds number is

  15. Dropwise Condensation Dropwise Condensation • Associated with higher heat-transfer coefficients than filmwise condensation phenomenon. • Attractive phenomenon for applications where extremely large heat-transfer rates are desired.

  16. Heat Transfer Equipment • Single-pass heat exchanger – fluid flows through only once. • Parallel or Co-current flow – fluids flow in the same direction. • Countercurrent flow or Counterflow - fluids flow in opposite directions. • Crossflow – two fluids flow at right angles to one another.

  17. Double pipe heat exchanger (A) and crossflow heat exchanger (B) A B

  18. Shell-and-tube Arrangement • E.g. Tube-side fluid makes two passes, shell-side fluid makes one pass. • Good mixing of the shell-side fluid makes one pass.

  19. Log-Mean Temperature Difference • Temperature profiles for single-pass double-pipe heat exchanger

  20. Counterflow analysis • Temperature vs. contact area

  21. Log-Mean Temperature Difference (continued) • First-law-of-thermodynamics • Energy transfer between the two fluids

  22. Log-Mean Temperature Difference (continued)

  23. Log-Mean Temperature Difference (continued) q = U*DT*dA CH* (TH2-TH1) = q

  24. Log-Mean Temperature Difference (continued)

  25. Example #1

  26. Example #1 (continued)

  27. Shell-and-Tube Heat Exchanger (1)

  28. Shell-and-Tube Heat Exchanger (2)

  29. Shell-and-Tube Heat Exchanger (3)

  30. Shell-and-Tube Heat Exchanger (4)

  31. Cross Flow Heat Exchanger (1)

  32. Cross Flow Heat Exchanger (2)

  33. Cross Flow Heat Exchanger (3)

  34. Example # 2 375 350 S, H, Water 280 -> 311.1 T, C, Oil 375-> 350 280 375 280 311.1 375 350

More Related